S12(X) Debugger Manual - Freescale Semiconductor

Debugger Interface
Debugger Main Window
Verify Code Button: Loader loads no data into memory, but reads back current data,
matching the same areas from the target memory, and compares all data with the data
from the selected file.
Open and Load Code Options Area
The checkboxes and buttons of this area of the Load Executable File window offer the
following options:
A checkbox specifying an automatic erase and program into Flash and EEPROM.
A checkbox to automatically verify the memory image after loading code, with two
radio buttons that let you define the memory image.
Checkbox to automatically run after successful load.
A checkbox to enable automatically stopping at the function specified in the textbox.
Connection Command Files Window
Choose Connection > Command Files to open the Connection Command Files window.
Each tab of this window, shown in Figure 2.17, corresponds to an event on which a
command file can be automatically run. See Startup Command File, Reset Command File,
Preload Command File, and Postload Command File.
Figure 2.17 Connection Command Files Window
The command file in the edit box executes when the corresponding event occurs. Click the
Browse button to set the path and name of the command file.
The Enable Command File check box allows you to enable/disable a command file on an
event. By default, all command files are enabled:
The default Startup command file is STARTUP.CMD,
The default Reset command file is RESET.CMD,
The default Preload command file is PRELOAD.CMD,
40 S12(X) Debugger Manual