S12(X) Debugger Manual - Freescale Semiconductor

Debugger Interface
Features of the User Interface
NOTE It is not possible to drag an expression defined with the Expression Editor. The
“forbidden” cursor appears.
Dragging from Source Component Window
Table 2.11 summarizes dragging from the Source Component.
Table 2.11 Dragging from the Source Component Window
Destination
Component Window
Action
Assembly Displays disassembled instructions starting at first highlevel
language instruction selected. Highlights assembler
instructions corresponding to selected high-level language
instructions in Assembly component.
Register Loads destination register with PC of first instruction
selected.
Memory Displays memory area corresponding with selected highlevel
language source code. Memory area corresponding to
selected instructions appears gray in memory component.
Data A selection in the Source window is considered an
expression in the Data window, as if entered through Data
component Expression Editor (see Data Component and
Expression Editor).
Dragging from the Memory Component Window
Table 2.12 summarizes dragging from the Memory Component.
Table 2.12 Dragging from the Memory Component Window
Destination
Component Window
Action
Assembly Displays disassembled instructions starting at first address
selected. Highlights instructions corresponding to selected
memory area in Assembly component.
Command Line Appends selected memory range to Command Line
window.
50 S12(X) Debugger Manual