2008 QX Quick Reference Guide - Infiniti Owner Portal

convenience
To Fold the 2nd Row Seats Flat:
1 Raise the armrest UP to the stowed position.
2 Pull the seat bottom release strap to fold the seat
bottom forward.
3 Then, pull UP on the seat reclining lever. The seatback
will flip forward and lock in place.
Note: There is a carpet panel flap on the back side of the seatback that can
be folded toward the back of the vehicle to provide a level cargo floor when
the 3rd row seats are also folded flat.
To Return the 2nd Row Seats to the Standard Position:
1 Return the carpet panel flap to the back side of the
seatback and secure it in place.
2 Pull UP on the seat reclining lever while you lift UP
and push BACK on the seatback. Return the seatback
to the upright position until it locks in place.
3 Return the seat bottom backward to its original
position until it locks in place.
4 Use the seat reclining lever to adjust the seat to the
desired position.
3rd Row 60-40 Split Bench Seats
The 3rd row 60-40 split bench seats can also be folded flat
for maximum cargo hauling/extra storage space.
Note: The power folding seats only operate when the transmission is in the
P (PARK) or N (NEUTRAL) position.
To Lower or Raise the 60-40 Split 3rd Row Bench Seats:
1 First, release and store the center seat belt and
retractor. (See 3rd row, Center Seat Belt Storage).
2 Lower the head restraints, then pull UP on the latch
located on the outside corner of each seatback and
fold the seatback forward.
3rd Row 60-40 Seats Power Folding (if so equipped):
1 Press and hold the DOWN portion of the left side 3rd
row seat switch to lower the driver’s side third row
seat, or the right-side switch controls to lower the
passenger-side third row seat.
2 To return the seats to an upright position, press the
UP portion of the corresponding switch.
38