EVT 168 servicemanual - Scootergrisen

More documents

Recommendations

Info

28 Tools Required: Y-bend socket wrench, 12mm Time: Allow 10 minutes for procedure 1. Release the screw on the rear caliper. 2. Remove the rear caliper. Brake Pad 3. Remove the brake pad from the base of the caliper. 4. Follow with the reversed steps to restore.
Direct Driven Hub-Motor Tools Required: Phillips screwdriver; open end wrench, 24mm Time: Allow 10 minutes for procedure 1. Release three screws on the motor cord cover. 2. Cut off the band. 3. Release the black connector of the motor cord. 4. Remove the rear caliper. 5. Release two nutes for the motor shaft. 6. Remove the orientation boards. 7. Remove the motor. 8. Follow with the reversed steps to restore. 29
Page 1 and 2: SERVICE MANUAL EVT-168
Page 3 and 4: Tools Required: Phillips screwdrive
Page 5 and 6: Tools Required: T-bend socket wrenc
Page 9 and 10: Tail Bracket Tools Required: Y-bend
Page 21 and 22: Tools Required: Open-end wrench, 10
Page 27 and 28: Brake Master Cylinder Tools Require
Page 29: Tools Required: Phillips screwdrive
Page 33 and 34: Tools Required: Box wrench, 17mm Ti
Page 35 and 36: Tools Required: Box wrench, 14mm Ti
Page 37 and 38: Current Meter and Speedometer Tools
Page 41 and 42: Time: Allow 10 minutes for procedur
Page 43 and 44: Tools Required: hex-key wrench (5mm
Page 45 and 46: Front Fork and Ball Race Tools Requ
Page 47 and 48: FIG.02 FORK Item NO. Part NO. Descr
Page 49 and 50: FIG.04 FRAME Item NO. Part NO. Desc
Page 51 and 52: FIG.06 HANDLE BAR Item NO. Part NO.
Page 53 and 54: FIG.08 TAIL LAMP Item NO. Part NO.
Page 55 and 56: FIG.10 FRONT COVER Item NO. Part NO
Page 57 and 58: FIG.12 FOOTREST BOARD Item NO. Part
Page 59: Accessories Item NO. Part NO. Descr

EVT 168 servicemanual - Scootergrisen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?