EVT 168 servicemanual - Scootergrisen

More documents

Recommendations

Info

40 Tools Required: Phillips screwdriver Time: Allow 10 minutes for procedure Throttle Cable 1. Follow page 22 ( step 1 to step 3) to pull the throttle pillar out. 2. Follow page 37 ( step 1 to step 3) to remove the handle switch. 3. Remove the throttle cable head on the handle grip. 4. Release the screw on the right handle switch. 5. Remove the throttle cable. 6. Follow with the reversed steps to restore.
Tools Required: hex-key wrench (5mm) Time: Allow 10 minutes for procedure Handle 1. Remove the instrument panel, handle switches (right and left) and brake master cylinder. 2. Release four screws on the handle Clamp. 3. Remove the handle. 4. Follow with the reversed steps to restore. 41
Page 1 and 2: SERVICE MANUAL EVT-168
Page 3 and 4: Tools Required: Phillips screwdrive
Page 5 and 6: Tools Required: T-bend socket wrenc
Page 9 and 10: Tail Bracket Tools Required: Y-bend
Page 21 and 22: Tools Required: Open-end wrench, 10
Page 27 and 28: Brake Master Cylinder Tools Require
Page 31 and 32: Direct Driven Hub-Motor Tools Requi
Page 33 and 34: Tools Required: Box wrench, 17mm Ti
Page 35 and 36: Tools Required: Box wrench, 14mm Ti
Page 37 and 38: Current Meter and Speedometer Tools
Page 41: Time: Allow 10 minutes for procedur
Page 45 and 46: Front Fork and Ball Race Tools Requ
Page 47 and 48: FIG.02 FORK Item NO. Part NO. Descr
Page 49 and 50: FIG.04 FRAME Item NO. Part NO. Desc
Page 51 and 52: FIG.06 HANDLE BAR Item NO. Part NO.
Page 53 and 54: FIG.08 TAIL LAMP Item NO. Part NO.
Page 55 and 56: FIG.10 FRONT COVER Item NO. Part NO
Page 57 and 58: FIG.12 FOOTREST BOARD Item NO. Part
Page 59: Accessories Item NO. Part NO. Descr

EVT 168 servicemanual - Scootergrisen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?