EVT 168 servicemanual - Scootergrisen

More documents

Recommendations

Info

32 Front Shock Absorber Tools Required: Phillips screwdriver; Y-bend socket wrench, 12mm Time: Allow 10 minutes for procedure 1. Remove the front fender. 2. Release the screw on the front fork cover and remove. 3. Release two screws on the front shock absorber and remove. 4. Follow with the reversed steps to restore.
Tools Required: Box wrench, 14mm Time: Allow 10 minutes for procedure 1. Remove the front cover. 2. Release the 6-pin connector. 3. Release the screw on the head lamp holder. 4. Follow with the reversed steps to restore. Head Lamp 33
Page 1 and 2: SERVICE MANUAL EVT-168
Page 3 and 4: Tools Required: Phillips screwdrive
Page 5 and 6: Tools Required: T-bend socket wrenc
Page 9 and 10: Tail Bracket Tools Required: Y-bend
Page 21 and 22: Tools Required: Open-end wrench, 10
Page 27 and 28: Brake Master Cylinder Tools Require
Page 31 and 32: Direct Driven Hub-Motor Tools Requi
Page 33: Tools Required: Box wrench, 17mm Ti
Page 37 and 38: Current Meter and Speedometer Tools
Page 41 and 42: Time: Allow 10 minutes for procedur
Page 43 and 44: Tools Required: hex-key wrench (5mm
Page 45 and 46: Front Fork and Ball Race Tools Requ
Page 47 and 48: FIG.02 FORK Item NO. Part NO. Descr
Page 49 and 50: FIG.04 FRAME Item NO. Part NO. Desc
Page 51 and 52: FIG.06 HANDLE BAR Item NO. Part NO.
Page 53 and 54: FIG.08 TAIL LAMP Item NO. Part NO.
Page 55 and 56: FIG.10 FRONT COVER Item NO. Part NO
Page 57 and 58: FIG.12 FOOTREST BOARD Item NO. Part
Page 59: Accessories Item NO. Part NO. Descr

EVT 168 servicemanual - Scootergrisen

Create successful ePaper yourself

Delete template?

Save as template?