THE GOLDMUND GOLDCUBE

5.1
AMPLIFIERS CONTROLS
On the front plate of the GOLDMUND GOLD CUBE are only
accessible:
The power key, used to power the amp on.
When activated. the speaker is connected after a very short
delay and the red LED switches on. The amp is powered off by
switching off the power key. The red led will fade very slowly,
indicating discharge of the filtering capacitors and the speaker
will be disconnected after few seconds.
5 .2 The two rail fuse sockets.
Each rail fuse holder is protected by a golden lid. which can be
removed using a coin. A red point LED, located near the fuse
indicate that the fuse is burned when it glows.
SOUND OUALITY OPTIM IZATION
6 .1 Warm-up sonic effect.
lf the power amplifier has not been powered off for a few days,
theoptimum sound quality is only reached after 3Ominutes. This
delay has been optimized to be minimal and the sonic quality
when lust powered on is much higher than other quality power
amplif iers.
6 .2 Speaker polarity.
Even if you have a phase inverter on your preamplif ier (as on the
GOLDMUND MIMESIS 2 or MIMESIS 7). and even if you have
carefully selected the proper line phase (see in next paragraph),
there is a possibility to again increase the sonic quality of your
speakers by reverting the polarity of the speaker cable amp
termination. But since the line phase and the speaker polarity
interfere to each other, you have to experiment carefully all the
combinations before picking the right one.
lf your preamp has an absolute phase inverter, this will interfere
too. lf it has not, don'tforgetthe result willdepend of the source.
most of the record and CD being recorded without care for the
absolute phase. Be patient..
-3-