caution - Thor Motor Coach
caution - Thor Motor Coach
caution - Thor Motor Coach
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Controls and Operations<br />
AUTOMATIC<br />
HYDRAULIC<br />
POWER LEVELERS<br />
50<br />
Automatic Leveling<br />
And Retraction<br />
Procedure<br />
FAILURE TO ACT IN ACCORDANCE WITH THE FOLLOWING<br />
MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.<br />
Read the entire operators manual and all pre<strong>caution</strong>s<br />
prior to operating this equipment.<br />
Do not use the jacks to change the tires. The system is designed as a leveling and<br />
stabilizing system and is not meant to lift the motor home off the ground.<br />
Do not operate any system functions while anyone is under the motor home.<br />
Make sure that people and pets are clear of the coach when operating the leveling<br />
system.<br />
Do not attempt to operate the system while the motor home is in motion.<br />
Never place hands or other parts of the body near hydraulic leaks. Oil may penetrate<br />
skin causing severe injury. Wear safety glasses when inspecting or servicing the<br />
system to protect eyes from dirt, metal chips, or leaks, etc. Follow all other applicable<br />
shop safety practices.<br />
The motor home should be parked on a fairly level surface. Ensure that there are<br />
no obstructions in the extend or retract paths of the jacks. If the surface is soft due<br />
to saturation or heat, place boards under the jacks to distribute the weight over a<br />
larger area. Using a board which measures approximately 2' wide by 2' in length is<br />
recommended. Ensure the front tires are pointing forward and not to the left or right.<br />
Note: Refer to manufacturer’s operations manual before operating.<br />
The automatic hydraulic power leveling system allows quick and easy leveling of the<br />
motor home from the driver’s seat by utilizing the system touch panel. The following<br />
instructions are general operating instructions.<br />
MAKE SURE THERE ARE NO OBSTRUCTIONS IN<br />
CAUTION THE EXTEND OR RETRACT PATHS OF THE JACKS.<br />
KEEP ALL PEOPLE CLEAR OF THE VEHICLE WHILE<br />
OPERATING THE LEVELING SYSTEM.<br />
Do not allow excessive motion in the motor home during the Auto-Level operation.<br />
This could cause the system to level improperly.<br />
1. TURN ON POWER. The power to the unit must be turned on. You need to have<br />
the ignition key in the ON position and the parking brake must be set to turn the control<br />
panel on. Push the POWER touch pad to engage power. The power touch pad should<br />
be lit when power is on.<br />
2. PRESS THE AUTO-LEVEL TOUCH PAD. The system will automatically level<br />
your vehicle. The control panel will send out a series of beeps to let you know that<br />
AUTO-LEVEL is operating. When completed, the panel will signal a successful Auto<br />
Level. After ten minutes, the panel will enter sleep mode.<br />
3. RETRACTING THE JACKS. Your Lippert System provides you with the ability<br />
to retract the jacks using the Retract All Jacks Button feature. Press and retract the<br />
Retract All Jacks Button. All jacks will automatically retract. The jacks are retracted<br />
when the Jacks Down light has gone out. Depending on the vehicle, full retraction<br />
may take up to 90 seconds.<br />
Note: Zero point, or level position has been preset at the factory.<br />
However, if you want to change the setting refer to the automatic<br />
hydraulic levelers owner's manual for detailed information regarding<br />
the proper procedures to do this.