Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4. INSTALLATION<br />
4.1 GENERAL<br />
Correct installation is very important for trouble-free and satisfactory operation of <strong>LPH</strong> <strong>35</strong>. It is suggested that<br />
each step of this section is carefully studied and followed.<br />
4.2 EQUIPMENT REQUIRED<br />
Source of clean and dry compressed air capable of forcing air flow rate of 150l/min @ 3,5 – 4,5 bar.<br />
Maximum air pressure at unit input should not exceed 7 bars.<br />
4.3 LOCATION<br />
Adequate ventilation is necessary to provide proper cooling of power source. Amount of dirt, dust and<br />
excessive heat, that unit is exposed to, should be minimised. Between <strong>LPH</strong> <strong>35</strong> and wall (or any obstruction)<br />
should remain distance of at least 300 mm, to secure proper air movement through it.<br />
CAUTION<br />
Installation of any kind of filtering device will reduce volume of through-flowing air, subjecting<br />
therefore interior of machine to overheating. Warranty is void if any type of filter device is employed.<br />
4.4 INSPECTION<br />
A. Remove shipping container and all packing stuff and inspect unit for any sign of damage.<br />
Notify transporters of any defects or damages at once.<br />
B. Check container for any loose parts before disposal.<br />
C. Check air louvers and any other openings to make sure any obstruction is removed.<br />
4.5 AIR LINES CONNECTIOINS<br />
To assembly air lines put on it hose clip and press in quick detachable coupling, that are delivered in<br />
container, and tighten clip next to hose end.<br />
4.6 PRIMARY ELECTRICAL CONNECTIONS<br />
! WARNING !<br />
ELECTRIC SHOCK CAN KILL! Precautionary measurements should be made to provide maximum<br />
protection against electric shock. Disconnect power cable from mains socket before any<br />
connections are made inside power source.<br />
! WARNING !<br />
Operator must make sure, if unit is properly configured for mains voltage. Unit configured for 3x400V<br />
MUST NOT be fed from 440V mains; it may get damaged.<br />
<strong>LPH</strong> <strong>35</strong> machines are equipped with 3m, 4-strands power cables for 3-phase mains connection. Switch<br />
board that unit is to be fed from must be equipped with proper line fuses or circuit breakers (see TECHNICAL<br />
DATA). Power cable may be connected directly to wall disconnect switch or be equipped with suitable plug.<br />
! WARNING !<br />
Chassis must be properly connected to ground. Otherwise it may result in electric shock, burns or<br />
death.<br />
47
Change language