Untitled - Senate Judiciary Committee

I B. METER-ACTIVATED REGENERATION
1. Follow steps 1 thru 4 under Cycle Controiler Checkout.
2. Turn on main electric-power switch and allow the cycleadjustment
knob to advance automatically to IDLE
position. This should take about five minutes.
3 Place matching pencil marks on the lower cam and backplate
to detect movement of the cycle-adjustment knob.
I
I
I
1
I
I
I
I I
I
I
I
I
I
4. Open cover plate on the water meter and manually rotate
the red pointer counter-clockwise to zero.’This will
close contact points and initiate the following steps:
a. The nickel pointer Will start to move counterclockwise.
b. As it passes zero, it will pick up the red pointer and
reset both at a pre-determined gallonage.
c. A solenoid coil will energize and advance the cycle
adjustment knob out of D LE position. After
approximately five minutes, the red light on the
bottom of the cycle controller will light and the
pilot motor will start.
d. The pilot motor will.advance the position dial 90 de
grees to BA.CKWASH (No. 2) position.-Thisco.no
firms that the electrical circuitry is operating properly:
Co ALTWINATOR CONTROL-METER-ACTIVATED
REGENERATION
1. Follow Steps 1 thru 3".under "’B’" Meter-Activated Regeneration.
2. Open cover plate on the water meter and manually rotate
the red pointer counter-clockwise to zero. This will
close contact points and initiate the following steps:
a. The nickel pointer will start to move counterclockwise.
b. As it passes zero, it will pick up the red pointer and
reset both at a pre-determined gallonage.
c. A signal will then be sent through the Altwinator
control to one of two cycle controllers, energizing
its solenoid and advancing its cycle adjustment
knob out of IDLE position. If Altwinator dial is
on LEFT, signal goes to the left unit and vice versa.
d. After approximately five minutes, the first tripper
switch in the cycle controller will activate, starting
the pilot motor. A red light will come on, indicating
the unit is in regeneration, and the posistion dial will
advance from SERVICE (No. 1) position to BACK-
. Simultaneously,
WASH (No. 2) position.
a signal is sent to start the Altwinator
pilot-motor, which indexes the pilot to take
.one unit off line and place the other unit on line.
Both Pointers
In Preset Position
Rotate Red Pointer
to Zero
Nickel Pointer
Also Moves to Zero
Both Pointers
Return to Preset
19