Chemical Engineering - The Petroleum Institute

O. Al-Ameri, M. Serhan, L. Lamont and L. El-Chaar, “Variable electronic load for testing PV performance”,
Journal of Applied Solar Energy, vol. 46, no.2, pp. 89-96, 2010.
**L. Lamont, L. El Chaar and C. Toms, “Using interactive problem-solving techniques to enhance control
systems education for non English natives”, European Journal of Engineering Education, vol. 35, no.1, pp.
99-108, 2010.
R. Mardiana and Q. Su, “Partial discharge location in power cables using a phase difference method”,
IEEE Transactions on Dielectrics and Electrical Insulation, vol. 17, no. 6, pp. 1738-1746, 2010.
M. Meribout, N. Al-Rawahi, A. Al-Naamany, A. Al-Bimani, K. Al-Busaidi and A. Meribout, “Design and
implementation of a new non-radioactive remote oil tank monitoring system”, IEEE Transactions on
Instrumentation and Measurement, vol. 59, no. 6, pp. 1507-1519, 2010.
M. Meribout, N. Al-Rawahi, A. Al-Naamany, A. Al-Bimani, K. Al-Busaidi and A. Meribout, “Integration of
impedance measurements with acoustic measurements for accurate two phase flow metering in case of
high water-cut”, Journal of Flow Measurement and Instrumentation, vol. 21, no. 1, pp. 8-19, 2010.
S. M. Muyeen, R. Takahashi, T. Murata and J. Tamura, “A variable speed wind turbine control strategy to
meet wind farm grid code requirements”, IEEE Transactions on Power System , vol. 25, no.1, pp. 331-340,
2010.
H.. M. Hasanien, S. M. Muyeen and J. Tamura, “Speed control of permanent magnet excitation transverse
flux linear motor by using adaptive neuro-fuzzy controller”, Energy Conversion and Management, vol. 51,
no.12, pp. 2762-2768, 2010.
H. M. Hasanien, S. M. Muyeen and J. Tamura, “Torque ripple minimization of axial laminations switched
reluctance motor provided with digital lead controller”, Energy Conversion and Management, vol. 51, no.12,
pp. 2402–2406, 2010.
S. M. Muyeen, R. Takahashi and J. Tamura, “Operation and control of HVDC-connected offshore wind
farm”, IEEE Transactions on Sustainable Energy, vol. 1, no.1, pp. 30-37, 2010.
S. M. Muyeen, R. Takahashi and J. Tamura, “Operation and control of HVDC-connected offshore wind
farm”, European Transactions on Electrical Power, vol. 20, no. 8, pp. 1071-1081, 2010.
F. Karami, J. Poshtan and M. Poshtan, “Detection of broken rotor bars in induction motors using nonlinear
Kalman filters”, ISA Transaction-Elsevier, vol. 49, no. 2, pp. 189-195, 2010.
C. Q. Su, “Case studies: Lessons learnt from the failure of a new 230kV transformer-cable termination”,
IEEE Electrical Insulation Magazine, vol. 26, no. 1, pp. 15-19, 2010.
C. Q. Su, “Rainwater harvesting on the sea: A new sustainable water resource”, Water International, vol.
35, no. 6, pp. 779-785, 2010.
Mechanical Engineering Department
M. Alshehhi, A. Shooshtari, S. Dessiatoun, M. Ohadi and A. Goharzadeh, "Parametric performance
analysis of an electrostatic wire-cylinder aerosol separator in laminar flow using a numerical modeling
approach", Separation Science and Technology, vol. 45, no. 3, pp. 299-309, 2010.
K. C. Leong, H. Y. Li, L. W. Jin and J. C. Chai, “Numerical and experimental study of forced convection in
graphite foams of different configurations”, Applied Thermal Engineering, vol. 30, no. 5, pp. 520-532, 2010.
H. Y. Li, K. C. Leong, L. W. Jin and J. C. Chai, “Analysis of fluid flow and heat transfer in a channel with
staggered porous blocks”, International Journal of Thermal Sciences, vol. 49, no. 6, pp. 950-962, 2010.
_____________________________________________________________________________________
- 16 -