Chemical Engineering - The Petroleum Institute

S. M. Muyeen, “Grid interfacing of a small scale DC-based wind farm using fuzzy logic controlled inverter
system”, in Conference Record of the XIX International Conference on Electrical Machines, Rome, Italy,
2010.
S. M. Muyeen and J. Tamura, “Performance evaluation of space vector modulation controlled inverter fed
variable speed wind generator during permanent fault”, In Conference Record of the XIX International
Conference on Electrical Machines, Rome, Italy, 2010.
K. Eloghene Okedu, S. M. Muyeen, R. Takahashi and J. Tamura, “Comparative study between two
protection schemes for DFIG-based wind generator”, in Conference Record of International Conference on
Electrical Machines and Systems, Incheon, S. Korea, 2010.
K. Eloghene Okedu, S. M. Muyeen, R. Takahashi and J. Tamura, “Stabilization of wind farms by DFIGbased
variable speed wind generators”, in Conference Record of International Conference on Electrical
Machines and Systems, Incheon, S. Korea, 2010.
M. Nakatani, S. M. Muyeen, R. Takahashi and J. Tamura, “New ESS connection scheme in wind generator
output smoothing control”, in Conference Record of International Conference on Electrical Machines and
Systems, Incheon, S. Korea, 2010.
J. Poshtan and M. Poshtan, “Analysis of the behavior of coupled loudspeakers in a MIMO ANC system in
an enclosure”, in Multi Conference on Systems and Control, Yokohama, Japan, 2010, p. 08.4.
J. Zarei, J. Poshtan and M. Poshtan, “Robust fault detection of non-linear systems with unknown
disturbances”, in Multi Conference on Systems and Control, Yokohama, Japan, 2010, p. 11.6.
F. Karami, J. Poshtan and M. Poshtan, “Broken bar fault detection in induction motors based on modified
winding function”, in Multi Conference on Systems and Control, Yokohama, Japan, 2010, p.09.5.
F. Karami, J. Poshtan and M. Poshtan, “Model-based fault detection in induction motors”, in Multi
Conference on Systems and Control, Yokohama, Japan, 2010, p. 09.6.
C. Q. Su, “Failure analysis of three 230kV XLPE cables”, in Proceedings of IEEE Transmission and
Distribution Conference, San Paulo, Brazil, 2010, pp. 1-4.
C. Q. Su, “A new maintenance strategy for the reduction of failure rate of distribution cables”, in
Proceedings of IEEE Symposium on Electrical Insulation, San Diego, USA, 2010, pp. 1-5.
K. Sack & C. Q. Su, “A non-contact directional sensor for partial discharge measurements”, in Proceedings
of IEEE Symposium on Electrical Insulation, San Diego, USA, 2010, pp. 1-5.
C. Q. Su, “Rainwater harvesting – a solution for the water crisis in the world?” in Proceedings of ASIA,
Kuching, Malaysia, 2010, pp. 1-6.
Mechanical Engineering Department
X. Kong, M. Alshehhi, A. Goharzadeh, A. Shooshtari, S. Dessiatoun and M. Ohadi, “Experimental
characterization of Ehd flow in an electrostatic air-oil droplets separator using particle image velocimetry”,
in ASME International Mechanical Engineering Congress and Exposition, Vancouver, Canada, 2010.
K. C. Leong, L. W. Jin, I. Pranoto, H. Y. Li. and J. C. Chai, “Experimental study of a two-phase
thermosyphon with porous graphite foam insert”, in 14 th International Heat Transfer Conference,
Washington DC, USA, 2010.
K. C. Leong, L. W. Jin, I. Pranoto, H. Y. Li. and J. C. Chai, “Experimental study of enhanced pool boiling
heat transfer using graphite foam inserts”, in 6 th International Conference on Diffusion in Solids and Liquids,
Paris, France, 2010.
_____________________________________________________________________________________
- 24 -