Commands - Force10 Networks

show interfaces private-vlan
ex Display the type and status of PVLAN interfaces.
Syntax show interfaces private-vlan [interface interface]
Parameters
Defaults None
Command Modes EXEC
EXEC Privilege
Command
History
Usage
Information
show interfaces private-vlan Display type and status of PVLAN interfaces.
show vlan private-vlan Display PVLANs and/or interfaces that are part of a PVLAN.
show vlan private-vlan
mapping
Display primary-secondary VLAN mapping.
switchport mode private-vlan Set the PVLAN mode of the selected port.
interface interface (OPTIONAL) Enter the keyword interface followed by one of the following
interface types:
1-Gigabit Ethernet: Enter gigabitethernet stack-id/slot/port.
10-Gigabit Ethernet: Enter tengigabitethernet stack-id/slot/port.
Port channel: Enter port-channel {1-511}.
Version 8.4.4.2 Introduced for VirtualScale on the E-Series ExaScale.
This command has two types of display — a list of all PVLAN interfaces or for a specific interface.
Examples of both types of output are shown below.
Examples Figure 2-1. show interfaces private-vlan Command Output
Force10# show interfaces private-vlan
Interface Vlan PVLAN-Type Interface Type Status
--------- ---- ---------- -------------- --------
Gi 0/2/5 101 Community Host Up
Gi 0/2/7 30 Community Host Up
Gi 0/4/0 10 Primary Promiscuous Up
Gi 0/4/1 102 Isolated Host Up
Gi 1/1/0 100 Primary Promiscuous Up
Gi 1/1/3 20 Community Host Up
Gi 1/1/5 10 Primary Trunk Up
Po 10 40 Isolated Host Up
Po 20 101 Community Host Up
Force10# show interfaces private-vlan Gi 1/1/0
Interface Vlan PVLAN-Type Interface Type Status
--------- ---- ---------- -------------- --------
Gi 1/1/0 100 Primary Promiscuous Up
Private VLAN (PVLAN) Commands | 19