Altec constructions catalog.

Slip protection for horizontal module assembly
Item No.
Material
119051000000 Stainless steel
An extra slip prevention is required for elevations with horizontal
arrangement. The slipping of the modules is therefore prevented and
also aids the assembly. The assembly occurs by simply fitting the
protection over the 40 x 40 profile.
Slip protection - tapping screw, A2
3
Item No.
Measurements
40BS00248016
M4.8 x 16 mm
This is used for modules which do not have drilled holes.
Slip protection, plastic
Item No.
Material
517057000100 Plastic
The bottom row of modules in any array is secured to prevent slipping.
For this purpose, in a vertical assembly each module in the bottom row
is fitted from the back with two slip-protectors into the frame (simple
snap-system), so that the slip protectors can be suspended above the
profile rails. This reduces assembly effort since the modules require no
alignment. Modules can be secured in the suspended position without
additional support. Assembly drill holes of 6 – 9 mm.
Slip protection - Cylinder head screw, A2
Item No.
Screw
109120206010 M6 x 10
The bottom row of modules in any array is secured to prevent slipping.
For this purpose, in a vertical assembly each module in the bottom row
is fitted with two cylinder head M6 x 10 screws from the back so that
the heads of the screws can be hooked into the profile rail or lie on it.
This reduces assembly effort since the modules require no alignment.
Modules can be secured in the suspended position without additional
support. Assembly drill holes of 6 – 9 mm.
45