Centralized Lubrication Chassis Systems for Trucks, Buses or Off ...

Centralized fluid grease lubrication for all rolling stock
with pneumatically operated piston pump PEU-98 or PEU-99 and VKR distributors
These systems are suitable for almost all trucks, buses,
construction equipment, etc . equipped with compressed
air.
The pneumatically operated piston pumps PEU-98 or
PEU-99 deliver approx. 50 cm3 (3 cu Inch) per pump
stroke, sufficient for centralized lubrication systems of
standard size trucks, buses and trailers .
Reservoir capacities : 4 or 3 liters .
Usable lubricants are : Fluid greases of NLGI grades
000, 00 .
The pump is activated by a solenoid valve .
Using the Impulse counter DSWM 21-2iS1, the pneumatically
operated piston pumps adapt also to systems for
trailer lubrication . See page 8.
PEU-98
The 2-, 4-and 6-ported VKR piston distributors distribute
and meter the iubricantfed by the pump . They pass the
lubricant premetered to the lubrication points .
Piston distributors feed lubricant while driving ; the
friction areas are moving and the bearings are capable
to receive new lubricant .
The IG 433-3 controller allows for timed on-off period
cycle control of the solenoid and pump action and
reports any faults via an indication lamp mounted on
the dashboard In the driver's cab .
VKR distributor systems may also operate with 12 V or
24 V, using the electrically operated gear pump unit
KFU 2 or KFU 6 and the IC 433-4 control unit that
monitors the on and off time of the gear pump unit .
See also page 6 .
PEU-99
piston distributors VKR,
2-, 4- and 6-ported
4
Centralized
Lubrication
will pay off your investment within one year
2430583203
http://legacy.library.ucsf.edu/tid/iux47e00/pdf