Panasonic VA-824 Installation and Programming.pdf - TextFiles.com

More documents

Recommendations

Info

Priority for simultaneous calling and receiving The following table shows the line connection priority when simultaneous callings and receivings occur. The prior calling or receiving takes priority of other callings or receivings in all cases other than those marked with a symbol “*‘I in the table. The line connection states for later callings or receivings are as shown in the table. Key telephone Later 1. incoming Incoming intercom call incoming incoming incoming Calling Calling ;;;;;; ;;in;! DSS TEL door box Paging sensor via via call l-7-4 ** *** call call signal COL intercom Incoming COL call Standby Standby * BT BT IT-2 Stopped IT-2 * * Hold call reminder Standby Standby * Incoming DSS TEL Standby Standby call orlT Voice Pa!in! access Incoming Standby Standby or IT IT Intercom call Tone paging access * Standby * Intercom door box * Standby * BT BT IT-2 Stopped IT-2 * * IT BT IT-2 Stopped IT-2 * * IT BT IT-2 Stopped IT-2 * * BT BT IT-2 Stopped IT-2 * * * * * Stopped IT-2 * * Intercom paging call * Standby * * * * - IT-2 * * CO1 ** IT Conversation *** Standby Standby IT Standby IT IT BT IT-2 Stopped IT-2 * * IT BT IT-2 Stopped IT-2 * * Intercom comversation EynTdby Standby IT IT BT IT-2 Stopped IT-2 * - In talk-back Eyydby Standby IT Door box conversation ~~~~dby Standby IT IT BT IT-2 Stopped IT-2 * - IT BT ICT Stopped IT-2 * - Pasing access ~~~~dby Standby IT IT BT IT-2 - IT-2 * - DSS TEL conversation ~~~~dby Standby IT IT BT IT-2 Stopped IT-2 * - Incoming sensor signal * * * * * * * * * * 141
Single line telephone Incoming Hold call COL call Reminder incoming Incoming Incoming DSS TEL intercom door box Hook-up call call call P PE -s o 3.E Incoming COL call = 8 Hold call Reminder Incoming DSS TEL call Incoming intercom call Standby Standby Standby Standby - * * BT ICT * * BT ICT * BT ICT * * BT ICT * During conversation Standby - BT BT ICT Incoming door box call Standby - I * I BT I ICT * I NOTE BT : Busy Tone. IT : Incoming call during Busy Tone. IT-2 : Door box being used is set to the IT state. Standby : Set to the IT state when COL off-hook Signaling is available, or set to the Standby State or IT when the same is not available. ICT : Incoming signal is heard at TEL under conversation. * : The prior state will be Standby or Stopped, while the later state will become effective. ** : When intercom off-hook singaling is available. *** : When intercom off-hook signaling is not available. 142
Page 2 and 3:
Thank you for purchasing the Panaso
Page 4 and 5:
1 89 EM CONNECTION LAYOUT Full syst
Page 6 and 7:
2. INSTALLATION OF KEY SERVICE UNIT
Page 8 and 9:
3. INSTALLATION OF KEY TELEPHONE Ho
Page 10 and 11:
Type of wires a CONNECTION OF WIRIN
Page 12 and 13:
5. CONNECTION OF OPTIONAL UNIT If y
Page 14 and 15:
( Connection of direct station sele
Page 16 and 17:
Connection Qf door box Make connect
Page 18 and 19:
Connection of SMDR - This system en
Page 20 and 21:
External music on hold source and e
Page 22 and 23:
6. CONNECTION OF POWER FAILURE UNIT
Page 24 and 25:
7. SPECIFICATIONS OF SYSTEM Modules
Page 26 and 27:
Check list of parts When you unpack
Page 28 and 29:
1. INITIAL SET LIST The table below
Page 30 and 31:
2. METHOD OF PROGRAMMING Read the f
Page 32 and 33:
flowchart A I ON/OFF key I I x 000
Page 34 and 35:
Automatic pause MODE You can place
Page 36 and 37:
Flash time MODE I You can set the l
Page 38 and 39:
System speed dial group A MODE I Yo
Page 40 and 41:
Long speech alarm When making an ou
Page 42 and 43:
COL night incoming ring mode MODE 1
Page 44 and 45:
Connection of door box MODE I Up to
Page 46 and 47:
Setisor alarm stopping method MODE
Page 48 and 49:
Connection of DSS This feature is t
Page 50 and 51:
Display time system setting This fe
Page 52 and 53:
SMDR YEAR, MONTH and DAY setting MO
Page 54 and 55:
SMDR frame configuration MODE 7 Thi
Page 56 and 57:
++ and # restriction MODE 6 In case
Page 58 and 59:
Incoming call restriction MODE 6 As
Page 60 and 61:
( COL setting MODE 2 Tone / Pulse d
Page 62 and 63:
Automatic outside line selection gr
Page 64 and 65:
Minimum pause You can change the mi
Page 66 and 67:
step ( Key telephone setting Teleph
Page 68 and 69:
For EXT. No. IO For EXT. No. 14 Lin
Page 70 and 71:
For EXT. No. 26 Line key No. 1 Prog
Page 72 and 73:
MODE 4 For EXT. No. 10 For EXT. No.
Page 74 and 75:
For EXT. No. 26 COL Program step LC
Page 76 and 77:
Door box call MODE 3 You can receiv
Page 78 and 79:
Zone paging MODE 3 Zones can be pag
Page 80 and 81:
Flexible night service setting MODE
Page 82 and 83:
I Outside dialing restriction class
Page 84 and 85:
MODE 6 For EXT. No. 18 COL 1 Progra
Page 86 and 87:
System speed dial restriction MODE6
Page 88 and 89:
Programming table for initial set S
Page 90 and 91:
FEATURE I OPTION SELECTED Restricti
Page 92 and 93:
COL setting Tel. No. FEATURE OPTION
Page 94 and 95: COL 5 Tel. No. : FEATURE OPTION SEL
Page 96 and 97: Key telephone setting Extension No.
Page 98 and 99: Extension No. 11 Room name: Interru
Page 100 and 101: Extension No. 12 Room name:
Page 102 and 103: Extension No. 13 Room name: No door
Page 104 and 105: 101 Extension No. 14 Room name:
Page 110 and 111: Extension No. 17 Room name: SELECTE
Page 114 and 115: Extension No. 19 Room name:
Page 118 and 119: Extension 21 Room name: from door b
Page 120 and 121: Extension (OPTION) Room name: from
Page 122 and 123: Extension No. 23 (OPTION) Room name
Page 126 and 127: 123 Extension No. 25 (OPTION) Room
Page 132 and 133: 129 Extension (OPTION) Room name:
Page 146 and 147: ( Tones and lamp indications :I---
Page 148 and 149: PROGRAMMING DESIGN TABLE (1/A- :- F
Page 150 and 151: KEY TELEPHON Enter KEY TEL or SLT S
Page 152 and 153: METHOD OF PROGRAMMING _.. Read the
Page 154 and 155: ogramming flowchart - 1 * 000 I ,l
Page 156 and 157: PROGRAMMING TABLE -. The set conten
Page 158 and 159: FEATURE OPTION SELECTED I Restricti
Page 160 and 161: COL setting Tel. No. : OPTION SELEC
Page 162 and 163: FEATURE OPTION Tel. No. : SELECTED
Page 164 and 165: Key telephone setting Extension No.
Page 166 and 167: Extension No. 11 Room name: Incomin
Page 168 and 169: I Extension No. 12 Room name: FEATU
Page 172 and 173: Extension No. 14 Room name: “NOOD
Page 174 and 175: Extension No. 15 Room name: nterrup
Page 184 and 185: Extension No. 20 Room name: 37
Page 186 and 187: Extension No. 21 Room name: 39
Page 194 and 195:
Extension No. 25 (OPTION) Room name
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
I I Extension No. 30 (OPTION) Room
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 214:
7E0004Z9AJ
show all

Panasonic VA-824 Installation and Programming.pdf - TextFiles.com

Create successful ePaper yourself

Delete template?

Save as template?