Panasonic VA-824 Installation and Programming.pdf - TextFiles.com

PROGRAMMING DESIGN TABLE (1/A- :-
For the system and each of the key telephones, perform programming designing according to
the following table.
SYSTEM
SETTING
FEATURE
CONTENTS
Enter dial No.0 to 9 of PBX outside line access dialing digits.
Enter dial No.0 to 9, digits of after the dialed auto pause.
Set the time for the conversation time indication appear to after 15 set or 30 sec.
Set the flash time to 0.6 set, 1 set or 2 sec. I I
Set the auto pause time to 2 set or 3 sec. I I
Enter the range of the system speed dial group A. (00 to XX)
Enter the range of the system speed dial group B. (YY to 89)
Performe the desired setting for long speach alarm.
Enter whether COL auto answering is performed at handset or at handset & ON/OFF key.
Set the COL night incoming ring for night ring set TEL or for COL ring set TEL.
Set the time of the hold recall to no recall,30 set, 1 min, 2 min or immediately.
Perform connection of the door box.
I
I
Select type of the sensor detecter type. I I
Select “By sensor” or “By handset” as a method of the sensor alarm stopping.
Set the SLT on-hook detection time more than 0.5 set or 1.2 sec.
Perform connection of the DSS
Set the time of the hold recall to no recall, 30sec, lmin, 2min or immediately. I I
I--- Set I+ area code or directly the digits of long distance call using the COL. I I
Apply the x and # restriction.
Enter the digit length 8 to 16 for the digit length restriction. I I
Possible or not to dial out with the line on which a call is received.
Enter dial Nos. (up to 4 digits) for outside dialing restriction override setting.
I
I
I
I
1