Installation Instructions - H&S Performance

More documents

Recommendations

Info

STEP 8 Remove turbo charger. This is done by removing the VGT actuator wire, two oil feed line bolts, up-pipe v band clamp, and the three turbo mounting bolts. It is strongly recommended to use penetrating oil on all turbo bolts, exhaust up pipe bolts, and pedestal bolts. Once these parts are removed the turbo will roll toward the passenger side of the truck and out of the pedestal. STEP 9 Remove intake horn by loosening clamp, and removing 4 bolts. 6 Ford 6.0L Powerstroke EGR/EGR Cooler Delete Kit <strong>Installation</strong> Manual
STEP 10 Remove 4 Fuel lines and disconnect 3 wire harnesses. (two of the wire harnesses are located on the backside of the oil filter housing not shown in picture) STEP 11 Remove the Oil and Fuel filter housing by removing 4 Hex bolts. STEP 12 Remove two bolts from coolant line. 1-888-628-1730 • www.hsperformance.com 7
Page 2 and 3: Warning! This high performance prod
Page 4 and 5: STEP 3 Remove the intake tube assem
Page 8 and 9: STEP 13 Remove two bolts that secur
Page 10 and 11: STEP 19 Remove EGR Cooler and coola

Installation Instructions - H&S Performance

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?