Leybold Oerlikon, Trivac NT16, NT25, Rotary Vane Vacuum Pump ...

Maintenance
Torque for the oil-fill plug and oil-drain plug: 10 Nm
Gasket: P/N: 239 55 165
We can only guarantee that the pump operates as specified by the
technical data if the lubricants recommended by us are used.
5.5 Cleaning the Inlet Screen
A wire-mesh sieve is located in the intake port of the pump to act as a dirt
trap for coarse particles. It should be kept clean to avoid a reduction of the
pumping speed.
For this purpose, remove the inlet screen (1.2/2) from the intake port and
rinse it in a suitable vessel with solvent. Then thoroughly dry it with compressed
air. If the inlet screen is defective, replace it with a new one.
The cleaning intervals depend on the application. If the pump is exposed to
large amounts of abrasive materials, a dust filter should be fitted into the
intake line.
Spider
Hub 2
Hub 1
Feeler gauge
5.6 Checking the Coupling
Here the backlash between coupling cams and the flexible spider must be
checked by a feeler gauge (see sketch 1).
When reaching the limit of wear of max. friction, the spider must be exchanged
immediately, independent of the inspection intervals.
The wear limit is at 3 mm!
In addition a visual inspection as to the presence of any damage needs to be
done. If damaged, the coupling must be replaced.
Sketch 1 Checking the wear limit
5.7 Replacing the Outer Shaft Seal
Required tools:
Allen keys 3 mm, 5 mm, 8 mm, flat-nose pliers, plastic hammer, shaft seal
driver, possibly puller for coupling.
The TRIVAC NT has two shaft seals; the outer one is subject to greater wear.
Oil marks under the coupling housing are signs of a damaged outer shaft
seal.
The outer shaft seal (5.2/8) can be replaced without removing or disassembling
the pump module.
Shutdown the pump.
Drain the oil (see Section 5.2) or place the pump on its front side.
Unscrew the four not counter-sunk hexagon socket screws at the intermediate
flange and detach the motor with the intermediate flange.
Remove the coupling element (5.2/1).
Remove the hex. socket screw (5.2/2) and the spring washer (5.2/3).
Pull off the coupling (5.2/4). Remove the key (5.2/5).
42 130002780_002_A0 - 12/2008 - © Oerlikon Leybold Vacuum