Clinch Fastening Systems
Clinch Fastening Systems
Clinch Fastening Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Clinch</strong> Nuts<br />
Strux® <strong>Fastening</strong> <strong>Systems</strong><br />
retaining ring<br />
lobular<br />
configuration<br />
retaining<br />
groove<br />
displacement<br />
lobes<br />
Features<br />
• Displacement lobes in TORX® configuration or<br />
others as required<br />
• Locking/retaining groove<br />
• Squeeze/retaining ring<br />
• Internal threads<br />
• Available in sizes M4 – M12 (#8 – 1/2")<br />
• Can be used in sheet metal 1.5mm and thicker<br />
• Unthreaded nuts available for use with TAPTITE®<br />
fasteners<br />
before installation<br />
after installation<br />
Installation Sequence (Representative Sample)<br />
Punched or drilled hole required. If needed, a locating pin holds the nut in place (shown). Installation equipment applies<br />
pressure onto the head of the nut and the opposite side of the application material. As pressure continues, the application<br />
material cold flows into the retaining/locking groove.<br />
6