Particlecounter Modell GT-526 Manual - ccs-wildberg.de

More documents

Recommendations

Info

4.3.5. Sample Hold Time The sample hold time is used when the sample mode is set to auto (continuous sample). The sample hold time represents the time from the completion of the last sample to the start of the next sample. The hold time could also be considered the amount of time between samples when no sampling is occurring. The sample hold time is user settable from 0 – 999 seconds and is discussed in section 4.4. 4.3.6. Sample Timing The following figures depict the sample timing sequence for both manual and auto sampling modes. Figure 10 shows the timing for manual sample mode. Figure 11 shows the timing for auto sample mode. 4.4. Sample Setup To access the sample settings select SAMPLE SETUP from the menu. Figure 12 shows the Sample Setup Screen. GT-526 9800 Rev A Seite | 16
4.5. Recalling Sample Data Stored sample events can be viewed from the Operate Screen (as described in section 4.2.2), but requires navigating one record at a time to reach a desired record. The Recall Data Screen provides a way to quickly navigate to a record based on time. The Recall Data Screen is accessed by selecting RECALL DATA from the main menu. If no sample events are available the screen shown in Figure 13 is displayed. To exit the No Samples Events Screen press the Start/Stop, ESC or Enter keys. Figure 14 shows the Recall Data Screen when there are sample events available. To recall data, enter the desired date/time string of the data to recall and select the START/STOP button. The unit will recall the data from the date/time entered (if an exact match is found) or the next most recent data available. The screen shown when the data is recalled is the Operate Screen. The screen reacts in exactly the same manner as described above and it now has the desired data shown. 4.6. Printing Sample Data Stored sample events can be printed through the printer port within a user selected range. The following sections describe the process of printing sample data. 4.6.1. Selecting Data Range To access the printing feature of the GT-526, select PRINT DATA from the menu. If no sample events are available the screen shown in Figure 15 is displayed. To exit the No Samples Events Screen press the Start/Stop, ESC or Enter keys. GT-526 9800 Rev A Seite | 17
Page 1 and 2: GT-526 9800 Rev A Particlecounter M
Page 3 and 4: Table of Contents 1. Introduction..
Page 5 and 6: 1. Introduction The GT-526 is a six
Page 7 and 8: GT-526 9800 Rev A Seite | 7
Page 9 and 10: 2.3. Default Settings The GT-526 co
Page 11 and 12: 3.2. Menu The GT-526 main menu prov
Page 13 and 14: The top line of the Operate Screen
Page 15: 4.2.3. Warnings The low battery war
Page 19 and 20: 4.7. Memory Management The GT-526 m
Page 21 and 22: BAUD This is the baud rate used for
Page 23 and 24: 4.12.1.Connection The baud rate for
Page 25 and 26: 4.12.4.Comma Separated Value (CSV)
Page 27 and 28: 3. Start and complete a sample. 4.
Page 29 and 30: 7. Electrical & Safety Conformity T

Particlecounter Modell GT-526 Manual - ccs-wildberg.de

Create successful ePaper yourself

Delete template?

Save as template?