V-SEAL Pipe Flashings For slate and tiled roofs - Brands of Watford
V-SEAL Pipe Flashings For slate and tiled roofs - Brands of Watford
V-SEAL Pipe Flashings For slate and tiled roofs - Brands of Watford
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
18 <strong>Pipe</strong> Flashing Systems – for <strong>slate</strong> <strong>and</strong> <strong>tiled</strong> <strong>ro<strong>of</strong>s</strong><br />
V-<strong>SEAL</strong> <strong>Pipe</strong> <strong>Flashings</strong><br />
<strong>For</strong> <strong>slate</strong> <strong>and</strong> <strong>tiled</strong> <strong>ro<strong>of</strong>s</strong><br />
Installation instructions<br />
1. Cut rubber cone to size along marked measurement lines using sharp pair <strong>of</strong> scissors<br />
or knife. Hole size <strong>of</strong> cone should be cut minimum 15mm smaller than outside<br />
diameter <strong>of</strong> pipe.<br />
2. Use water as lubricant when sliding flashing down pipe.<br />
3. <strong>For</strong>m an anti-capillary fold at the top <strong>of</strong> the base as shown.<br />
4. Place flashing under the top tiles.<br />
5. H<strong>and</strong> form base all around <strong>and</strong> cut <strong>and</strong> form holding tabs as shown.