19.02.2014 Views

2013 Michael Phelps Swim Spa RX Owner's Manual - Master Spas

2013 Michael Phelps Swim Spa RX Owner's Manual - Master Spas

2013 Michael Phelps Swim Spa RX Owner's Manual - Master Spas

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

SPA TROUBLE-SHOOTING GUIDE<br />

Propulsion System (CONT.)<br />

Light will not turn on<br />

1. Verify that light switch is on<br />

2. Verify that appropriate voltage is being supplied to light<br />

3. Replace light<br />

NOTE - Max. frequency setting f/wave XP Pro: 68 HZ.<br />

FILTRATION<br />

Filter pump will not turn on<br />

1. Verify that E-stop is not tripped<br />

2. Check voltage to filter pump contactor<br />

3. Verify that contactor coil is getting the appropriate voltage when E-stop is active<br />

My chemicals are balanced (PH, TA, Sanitizer), but my water is cloudy<br />

1. Shut down unit until problem is remedied and water is clear<br />

2. Clean/replace filter<br />

3. Review bather load and consult with pool professional<br />

Serviceable Components:<br />

Included serviceable components:<br />

• G.F.C.I./Breaker Assembly<br />

• E-stop<br />

• Spring wound timer<br />

• VFD<br />

• Propulsion Motor<br />

• Propulsion transmission system<br />

• Belts<br />

• Pulleys<br />

• Bearing/hub assembly<br />

• Propeller<br />

Optional serviceable<br />

components:<br />

• Electrical control box<br />

• Filter pump<br />

• Jet pump 1<br />

• Jet pump 2<br />

• Light<br />

• Filter<br />

• Chlorinator<br />

Other possible serviceable<br />

components:<br />

• Chemical maintenance<br />

system<br />

• Heater<br />

• Ozone Generator<br />

• UV System<br />

• Other water sanitization<br />

system<br />

CRITICAL REPLACEMENT COMPONENTS:<br />

WARNING - Items listed below shall only be replaced with identical components unless approved<br />

by <strong>Master</strong> <strong>Spa</strong>s engineering department.<br />

• Propulsion suction grate assembly: X804490<br />

• Propulsion grate fasteners (4 per grate): X717900<br />

• Propeller f/wave XP Pro: X400820<br />

PROPULSION SUCTION GRATES MISC. SPECIFICATIONS:<br />

• Maximum VFD frequency – 68Hz.<br />

• Wall mount only<br />

• Grate / frame assembly P/N – X804490<br />

• Propulsion grate fastener P/N – X717900<br />

40<br />

• Propeller P/N –X400820<br />

• Life span 7 years<br />

• Tools required – No. 2 Phillips screwdriver<br />

• Pulley system shall be 1:1 ratio only<br />

NOTE - Fitting and fasteners should be observed for damage or tampering before each use of the spa.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!