Setting Up Your Air Bed - InnoMax

More documents

Recommendations

Info

5. Place the air inflation unit on the floor at the head of the bed with the air ports facing away from the bed. If the unit will be used on a hardwood or tile floor, it is recommended that a towel or other dampening material be placed under the unit to minimize vibration noise. Use A Surge Protector To * Prevent Pump Damage. POINT CONTROL TOWARDS FOOT WHEN FILLING TO INFLATE CORRECT SIDE OF BED. WALL RIGHT PORT LEFT PORT PLACE INFLATOR UNDER THE BED FRAME WITH THE PORTS FACING THE WALL. * If you have the Synergy Tri-Zone System, skip step 6 * 6. The barrels on the end of the air hoses are designed to attach to the air port using the patented Twist N’ Lock system. The connection is made with a slight counter clockwise turn. To lock the connection, simply twist the entire barrel/hose clockwise to add tension to the support spring inside the hose. Slide the barrel over the air port coming from the inflator and gently release the connector in a counterclockwise fashion. This should snugly lock the barrel into place. It is important to double check this connection before proceeding to inflate the chambers. Failure to do so may result in a slow air loss which can affect your comfort. Inflate both sides of the mattress, one at a time, using the hand held control(s). If your inflator has the “<strong>Bed</strong> Fill” feature, simply push this button to fill the chamber automatically. If it does not have this button, press and hold the “Firm” Button until chamber is completely inflated. On digital inflators, the reading will be approximately 50 mmHg. For analog inflators, the pump will begin to slow down & will create a sputtering sound. This will signal a full chamber. The inflators are designed to prevent damage to the chamber from overfilling. 3 Repeat this process for the opposite side of the bed. * DO NOT OVER TIGHTEN *
* If you have the Vulcanized <strong>Air</strong> System, skip step 7 * 7. The Synergy® 4-port Digital inflator features two ports for each side of your bed. One controls the firmness of the head and foot chambers, while the other is for adjusting the mid-body chamber. The clear hose with the “Y” should be attached to the Head & Foot port, with the remaining hose going to the midbody port on the pump. Repeat this for the other side of the sleep system. To inflate the bed, the memory 2 button can be depressed and released, the bed will inflate to the highest setting (40 mmHg). The pump can only operate one side of the bed at a time. Repeat this for the other side. Note: Step 8 is not required for the Synergy® sleep system. Due to the size of the chambers the comfort layer is not needed. 8. Place the comfort layer on top of the air chambers. This should completely cover the chambers and drop just inside the Power Edge Support Rail System. 9. Zip up the cover/pillow top, install new mattress pad and sheets. Enjoy a great night’s rest. 4
Page 1 and 2: AIR SUPPORT ASSEMBLY INSTRUCTIONS 1
Page 3: 4.) Install the air chambers with t
Page 7: Troubleshooting Tips for Air Chambe

Setting Up Your Air Bed - InnoMax

Create successful ePaper yourself

Delete template?

Save as template?