System Catalogue - LISA

M3K AND M3KP − POINT-TO-POINT CABLING SYSTEM
M3K
fiber tray and loose tube
M3K
WAN - Central office
M3KP
Pre-terminated and factory tested the M3K assembly is loaded
into a LISA fiber tray unit allowing high fiber count links
to be constructed on site in a matter of minutes without the
need for costly and time-consuming splicing.
Both ends of the M3K assembly can be fitted to a fiber tray
unit in an ODR or ODU or if preferred, a standard breakout
can be used at one end for direct termination to in-line suite
equipment racks.
direct fixation to
rack/equipment
Pull-socks can be fitted to either end of the M3K assembly
(not FT end of M3KP) and offer complete protection when
routing through duct system or simply storing under floor
prior to installation. MASTERLINE end can be housed internally
within LISA 19" MASTERLINE CTBs for well protected
rack-to-rack fiber links or used for patching to the front side
of customer equipment.
termination to
fiber panel
(CTB) in rack
M3KP is a variant of the M3K allowing 24 fibers to be
terminated in a single fiber tray by using 250 μm fibers and
SFF connectivity, such as LX.5 and LC.
Features
• reduces on-site installation time
• supplied ready-to-install
• all connector types available
• up to 12 × 1.7 mm ruggedised fibers using M3K
• up to 24 × 250 micron fibers using M3KP
• pull-sock can be fitted for pulling through ducting systems
• integrates seamlessly with enclosures housing fusion
spliced fiber trays
• improved protection of fiber break-outs
loose tube cable (line)
patchcord
cable between M3K and system rack
www.hubersuhner.com/lisa
63