Page 1 of 4 2004 Explorer Sport Trac Workshop Manual 3/29/2009 ...
Page 1 of 4 2004 Explorer Sport Trac Workshop Manual 3/29/2009 ...
Page 1 of 4 2004 Explorer Sport Trac Workshop Manual 3/29/2009 ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>2004</strong> <strong>Explorer</strong> <strong>Sport</strong> <strong>Trac</strong> <strong>Workshop</strong> <strong>Manual</strong><br />
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS4R/~MUS~LEN/20/S...<br />
<strong>Page</strong> 4 <strong>of</strong> 4<br />
3/<strong>29</strong>/<strong>2009</strong><br />
<br />
Is the resistance greater than 10,000 ohms?<br />
G11 CHECK CIRCUIT 117 (PK/BK) FOR AN OPEN<br />
Disconnect the following connectors:<br />
passenger door lock actuator C603<br />
driver door lock actuator C525<br />
driver rear door lock actuator C704<br />
passenger rear door lock actuator C804<br />
Measure the resistance between vehicle security module C274b pin 22, circuit 117 (PK/BK), harness<br />
side and all door lock actuators, circuit 117 (PK/BK), harness side.<br />
Yes<br />
GO to G12.<br />
No<br />
REPAIR the circuit. TEST the system for normal operation.<br />
<br />
Are the resistances less than 5 ohms?<br />
G12 CHECK CIRCUIT 118 (PK/OG) FOR AN OPEN<br />
Measure the resistance between the vehicle security module C274b pin 11, circuit 118 (PK/OG),<br />
harness side and passenger door lock actuators, circuit 118 (PK/OG), harness side.<br />
Yes<br />
GO to G13.<br />
No<br />
REPAIR the circuit. TEST the system for normal operation.<br />
<br />
Are the resistances less than 5 ohms?<br />
G13 CHECK CIRCUIT 163 (RD/OG) FOR AN OPEN<br />
Measure the resistance between vehicle security module C274a pin 1, circuit 163 (RD/OG), harness<br />
side and driver door lock actuator C525, circuit 163 (RD/OG), harness side.<br />
Yes<br />
GO to G14.<br />
No<br />
REPAIR the circuit. TEST the system for normal operation.<br />
Are the resistances less than 5 ohms?<br />
G14 CHECK THE VEHICLE SECURITY MODULE FOR CORRECT OPERATION<br />
Disconnect all vehicle security module connectors.<br />
Check for:<br />
corrosion<br />
pushed-out pins<br />
Connect all vehicle security module connectors and make sure they seat correctly.<br />
Reconnect the battery. Refer to Section 414-01.<br />
Operate the system and verify the concern is still present.<br />
Is the concern still present?<br />
Yes<br />
INSTALL a new vehicle security module. REFER to Section 419-10.<br />
CLEAR the DTCs. REPEAT the self-test.<br />
No<br />
The system is operating correctly at this time. Concern may have<br />
been caused by a loose or corroded connector. CLEAR the DTCs.<br />
REPEAT the self-test.
Change language