Explorerfix Child Car Seat - Kiddicare

Adjusting the harness for the size of the child (see illustrations 24 - 25)
• Use the knobs on the sides of the headrest to adjust the harness to the height of the child
(fig. 24 - 25).
• The correct position of the shoulder straps is never above or below the child’s neck.
Operating the harness
• Fasten the buckle.
• Tighten the shoulder straps by pulling the end of the harness adjustment strap until it fits
correctly, taking care to always leave some room for movement.
• To loosen the seat straps, press the TMS forwards and pull the shoulder straps with the
other hand.
IMPORTANT: Make sure that the straps of the seat are not twisted when the child is
using it. It is very important to make sure that the lap section of the harness is positioned as
low as possible so the pelvis is firmly secured.
Adjusting the seat (see illustrations 26 - 27)
• The position of the seat can be changed easily with just one hand by pressing the lever
situated on the front part of it (fig. 26 - 27)
IMPORTANT: Make sure that the seat is not in-between two positions, a click will
indicate that it is in the right position.
Closing the harness buckle (see illustrations 28)
• To fasten the harness buckle of the seat put the two parts together and insert them into
the female part with the red button, pressing until it clicks (fig. 28).
• Press the red button to open it.
• Check that the straps are not twisted.
GROUP 2 (15 - 25 KG.)
Dismantling the harness (see illustrations 29 - 30)
• For easier access to the metal distribution plate, press the TMS forward and pull the
shoulder straps with the other hand (fig. 29).
• Unhook both shoulder straps from the metal distribution plate (fig. 30).
• Next, detach the chest protectors, removing the clips that fasten them, from the rear part
of the frame.
• Release the lap section of the harness from the buckle.