FW430E - VITEC - Professionelle Audio Video Systeme

Long-Lasting Brightness and
Excellent Cost Savings
PT-FW430 Series
LCD Projectors
PT-FW430E
PT-FX400E

Specifications
Model
Power supply
Power consumption
LCD panel
Lens
Panel size
Display method
Pixels
Pixel configuration
Lamp
Screen size (diagonal)
Brightness* 3
Centre-to-corner uniformity* 3
Contrast* 3
Resolution
100 –240 V AC, 3.9 –1.4 A, 50/60 Hz
330 W (0.4 W at 220 –240 V AC, 0.3 W at 100 –120 V AC when standby mode set to eco* 1 PT-FW430E
PT-FX400E
,
9 W when standby mode set to normal, 20 W when standby mode set to normal and audio monitor out.)
18.9 mm (0.74 inches) diagonal (16:10 aspect ratio) 20.3 mm (0.8 inches) diagonal (4:3 aspect ratio)
Transparent LCD panel (× 3, R/G/B)
Transparent LCD panel (× 3, R/G/B)
1,024,000 (1,280 × 800) × 3, total of 3,072,000 pixels 786,432 (1,024 × 768) × 3, total of 2,359,296 pixels
Stripe
Stripe
Manual 2× zoom (throw ratio: 1.34 – 2.68:1), Manual 2× zoom (throw ratio: 1.48 –2.96:1),
manual focus F 1.7– 2.6, f 21.6– 43.0 mm manual focus F 1.7–2.6, f 24.0 – 47.2 mm
250 W UHM lamp (The lamp replacement cycle is 6,000 hours.* 2 )
0.84 –7.62 m (33 – 300 inches), 16:10 aspect ratio 0.84 –7.62 m (33 – 300 inches), 4:3 aspect ratio
3,500 lm (lamp mode: normal)
4,000 lm (lamp mode: normal)
80%
600:1 (full on/full off)
1,280 × 800 pixels (Input signals that exceed this
resolution will be converted to 1,280 × 800 pixels.)
1,024 × 768 pixels (Input signals that exceed this
resolution will be converted to 1,024 × 768 pixels.)
fH: 27.0 kHz – 68.7 kHz; fV: 24.0 Hz – 85.0 Hz; dot clock: 25.2 MHz– 148.5 MHz
fH: 15 .6 kHz – 91.1 kHz; fV: 24.0 Hz – 85.1 Hz; dot clock: 162 MHz or lower
fH: 15.75 kHz; fV: 60 Hz (NTSC/NTSC4.43/PAL-M/PAL60), fH: 15.63 kHz; fV: 50 Hz (PAL/PAL-N/SECAM)
Vertical: ±30°
Ceiling/desk, front/rear
Output power: 5.0 W (monaural)
HDMI 19-pin × 1 (Deep Colour, compatible with HDCP)
480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p, 1080/60p, 1080/50p,
VGA (640 × 480) – WSXGA+ (1,680 × 1,050), compatible with non-interlaced signals only;
dot clock: 25.2 –146.25 MHz;
Audio signal: linear PCM (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz)
DVI-I 29-pin × 1
Digital: (DVI 1.0 compliant, compatible with HDCP, compatible with single link only)
480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p, 1080/60p, 1080/50p,
VGA (640 × 480) – WSXGA+ (1,680 × 1,050), compatible with non-interlaced signals only;
dot clock: 25.2 –146.25 MHz;
Analogue: (RGB/YPBPR (YCBCR))
D-sub HD 15-pin (female) × 1 (RGB/YPBPR × 1)
RCA pin × 1 (composite video)
Mini DIN 4-pin × 1 (S-Video)
M3 × 1 (L, R × 1), 0.5 Vrms
M3 × 1 (L, R × 1), 0.5 Vrms
RCA pin × 2 (L, R × 1), 0.5 Vrms
M3 × 1 (L, R × 1) (monitor out: 0 – 2.0 Vrms, variable)
D-sub 9-pin (female) × 1 for external control (RS-232C compliant)
RJ-45 × 1 (for network connection, 10Base-T/100Base-TX, compliant with PJLink)
Connector for optional wireless module ET-WM200E × 1
Moulded plastic (PC+ABS)
430 × 125.5* 4 × 323 mm (16-15/16˝ × 4-15/16˝ * 4 × 12-23/32˝ ) (Protruding parts not included)
Approximately 6.0 kg (13.2 lbs.)
Operating temperature: 0°C– 40°C (32°F– 104°F)* 5 Scanning HDMI/DVI-I (digital)
frequency DVI-I (analogue)/RGB
YPBPR (YCBCR) fH: 15.75 kHz; fV: 60 Hz (480i [525i])
fH: 33.75 kHz; fV: 60 Hz (1080 [1125]/60i)
fH: 31.50 kHz; fV: 60 Hz (480p [525p])
fH: 28.13 kHz; fV: 50 Hz (1080 [1125]/50i)
fH: 15.63 kHz; fV: 50 Hz (576i [625i])
fH: 27.00 kHz; fV: 24 Hz (1080 [1125]/24p)
fH: 31.25 kHz; fV: 50 Hz (576p [625p])
fH: 33.75 kHz; fV: 30 Hz (1080 [1125]/30p)
fH: 37.50 kHz; fV: 50 Hz (720 [750]/50p)
fH: 67.50 kHz; fV: 60 Hz (1080 [1125]/60p)
fH: 45.00 kHz; fV: 60 Hz (720 [750]/60p)
fH: 56.25 kHz, fV: 50 Hz (1080 [1125]/50p)
Video/S-Video
Optical axis shift Vertical
±51% from centre of screen (manual)
±50% from centre of screen (manual)
Horizontal ±24% from centre of screen (manual)
±27% from centre of screen (manual)
Keystone correction range
Installation
Built-in speaker
Terminals HDMI IN
DVI-I IN
COMPUTER (RGB) IN
VIDEO IN
S-VIDEO IN
AUDIO IN 1
AUDIO IN 2
AUDIO IN 3
AUDIO OUT
SERIAL IN
LAN
WIRELESS MODULE
Cabinet materials
Dimensions (W × H × D)
Weight
Operating environment
; operating humidity: 20%–80% (no condensation)
Supplied accessories
Power cord, wireless remote control unit, batteries (R6 type × 2), software CD-ROM (Logo Transfer
Software, Multi Projector Monitoring & Control Software Ver. 2.5, Wireless Manager ME 5.5)
*1 When the standby mode is set to eco, network functions such as power on over the
LAN will not operate. Also, only certain commands can be received for external control
*3 Measurement, measuring conditions and method of notation all comply with ISO
21118 international standards.
using the serial terminal.
*2 This value is calculated by continuously turning the lamp on for 2 hours and off for
0.25 hours. The lamp replacement cycle will decrease if the lamp is turned on/off
more frequently, or if it is left on for longer intervals.
*4 With legs at shortest position.
*5 The operating temperature range is 0°C to 35°C (32°F to 95°F) when used in High-
Altitude mode (1,400 m to 2,700 m (4,593 ft to 8,858 ft)).
NOTES ON USE
1. Do not install the projector in locations that are subject to excessive water, humidity, steam or oily smoke. Doing so may result in fire, malfunction or electric shock.
2. The projector uses a high-voltage mercury lamp that contains high internal pressure. This lamp may break, emitting a large sound, or fail to illuminate, due to impact or
extended use.
3. The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions:
• Never place objects on top of the projector while it is in operation.
• Make sure there is an unobstructed space of 500 mm (19-11/16 in) or more around the projector’s intake and exhaust openings.
• Do not stack projector units directly on top of one another for the purpose of multiple (stacked) projection.
When stacking projector units, be sure to provide the amount of space indicated between them. These space requirements also apply to installation where only one
projector unit is operating at one time and the other unit is used as a backup.
• If the projector is placed in a box or enclosure, the temperature of the air surrounding the projector must be between 0°C (32°F) and 40°C (104°F). Also, make sure
the projector’s intake and exhaust openings are not blocked. Take particular care to ensure that hot air from the exhaust openings is not sucked into the intake.
4. The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods.
• The length of time that it takes for the lamp to break or fail to illuminate varies greatly depending on individual lamp characteristics and usage conditions.
• The brightness of the lamp will gradually decrease with use.
5. Due to natural characteristics of lamps, screen brightness may vary (flicker). This is not an indication of faulty lamp performance.
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
Product availability differs depending on region and country. This product may be subject to export control regulations.
All other trademarks are the property of their respective trademark owners. Projection images simulated.
© 2011 Panasonic Corporation. All rights reserved.
Dimensions
Projection Distance
unit: metres (feet)
PT-FW430E (16:10 aspect ratio; throw ratio: 1.34–2.68:1)
Projection size
(diagonal)
Projection distance
Min Max
(wide) (telephoto)
Height from edge
of screen to centre
of lens
0.84 m
33˝
–
(–)
1.8
(6.0)
0 – 0.45
(0 – 1.5)
1.02 m
40˝
1.1
(3.6)
2.3
(7.4)
0 – 0.54
(0 – 1.8)
2.03 m
80˝
2.3
(7.4)
4.6
(14.9)
-0.01 – 1.09
(0 – 3.6)
3.05 m
120˝
3.4
(11.2)
6.9
(22.5)
-0.02 – 1.63
(-0.1 – 5.3)
5.08 m
200˝
5.7
(18.8)
11.5
(37.6)
-0.03 – 2.73
(-0.1 – 8.9)
7.62 m
300˝
8.6
(28.3)
17.2
(56.5)
-0.05 – 4.09
(-0.2 – 13.4)
PT-FX400E (4:3 aspect ratio; throw ratio: 1.48–2.96:1)
Projection size Projection distance
(diagonal) Min Max
PT-FW430 - E (16:10) (wide) (telephoto)
Height from edge
of screen to centre
of lens
0.84 m
33˝
–
(–)
1.9
(6.4)
0 – 0.50
(0 – 1.7)
1.02 m
40˝
1.2
(3.8)
2.4
(7.8)
0 – 0.61
(0 – 2.0)
2.03 m
80˝
2.4
(7.8)
4.8
(15.7)
0 – 1.22
(0 – 4.0)
3.05 m
120˝
3.6
(11.9)
7.2
(23.6)
0 – 1.83
(0 – 6.0)
5.08 m
200˝
6.1
(19.9)
12.0
(39.5)
0 – 3.05
(0 – 10.0)
7.62 m
300˝
9.1
(29.9)
18.1
(59.3)
0 – 4.57
(0 – 15.0)
Optional Accessories
ET-PKF110H
PT-FX400 - E (4:3)
Ceiling mount
bracket for
high ceilings
ET-WM200E
Wireless module
Freeware
430 (16-15 /16 )
Multi Projector
Monitoring and
Control Software
Ver. 2.5
ET-EMF100
Replacement
filter unit
125.5
(4-15 /16 )
unit: millimetres (inches)
323 (12-23 / 32 )
ET-PKF110S
Ceiling mount bracket
for low ceilings
ET-LAF100A
Replacement
lamp unit
For more information about Panasonic projectors
http://panasonic.net/avc/projector
JQA-0443 EC98J2010
051
Factories of Systems Business Group have received ISO 14001:2004—
the Environmental Management System certification (except for third
parties’ peripherals).
All information included here is valid as of March 2011.
PT-FW430E1 Printed in Japan.