SERVICE MANUAL Colour Television - diagramas.diagram...

Purity and Convergence Adjustment
CONVERGENCE ADJUSTMENT
Preparation: After carrying out purity adjustment and
before proceeding to convergence
adjustment, provisionally insert the rubber
wedge so that there is no vertical or
sideways play in the deflection yoke.
Signals: Display a crosshatch pattern.
Figure 5
FOUR-POLE
MAGNET TABS
ANGLE
OF TABS
1
2
SIX-POLE
MAGNET TABS
3
4
1. Red/blue center adjustment
Adjust the angle between the tabs (1) and (2) in Figure
5 and rotate them together until the lines of the red and
blue crosshatch patterns (vertical and horizontal lines)
are superimposed in the center of the screen.
Figure 6
PURITY
MAGNET
TABS
2. Green and red/blue center adjustment
Adjust the angle between the tabs (3) and (4) in Figure
5 and rotate them together until the lines of the green
crosshatch pattern are superimposed with the red/blue
crosshatch pattern (vertical and horizontal lines) which
were superimposed in step 1).
Figure 7
Red
Blue
Adjust the angle rotation of tabs
(1) and (2) to align the vertical
and horizontal lines.
3. Vertical lines at screen center (Red and Blue)
Use the VR2 control (see Figure 8) at the top of the
deflection yoke to correct the vertical line convergence
at the center of the screen.(See Figure 9.)
Red/Blue
Green
Adjust the angle and rotation of
tabs (3) and (4) to align the vertical
and horizontal lines.
4. Vertical lines at screen top and bottom
Use the VR1 control (see Figure 8) at the top of the
deflection yoke to correct the vertical line convergence
at the top and bottom of the screen. (See Figure 10.)
Figure 9
Use the VR2 control to correct.
5. Horizontal lines at screen top and bottom
Rotate the Deflection yoke to the left or right to correct
the horizontal line convergence at the top and bottom of
the screen. (See Figure 11.)
If vertical lines are intersecting at the top and bottom,
use a screwdriver to adjust the Balance coil at the top of
the deflection yoke. (See Figure 12.)
Red
Figure 10
Blue
Use the VR1 control to correct.
Figure 8
Blue
Red
VR1
Balance
coil
Figure 11
Red
Blue
VR2
Rotate the DY to correct.
Figure 12
Red
Blue
Use the Balance coil to correct
-19-