Photovoltaic Solar Inverter Series ES - Effekta

More documents

Recommendations

Info

Photovoltaic Solar Inverter Series ES Communication interfaces 8.3.5 Relay contact of card (DCE-B card) The pin assignment for the 10 pin terminal: Pin 1: DC input voltage inside and DC input voltage below the range Pin 2: at lest one DC input beyond the min. limit Pin 3: all DC input voltages below min. limit Pin 4: Frequency of AC output (network) out of tolerance Pin 5: island solution switched off Pin 6: Output current of the inverter above the tolerance Pin 7: The heat sink temperature of the inverter is too high Pin 8: Common Each relay contact can bear a load of max 40 VDC / 25 mA. You can switch over the output signal from N.C. (normal close) to N.O. (normal open) by bridging Pin 1 and 2 or Pin 2 and 3 from JP1-5 with the jumpers. ES series 46
Photovoltaic Solar Inverter Series ES Communication interfaces 8.3.6 SNMP card You will find more information and installation information in the documents that accompany the SNMP card. ES series 47
Page 1 and 2: Photovoltaic Solar Inverter Series
Page 7 and 8: Photovoltaik Wechselrichter Serie E
Page 45: Photovoltaic Solar Inverter Series

Photovoltaic Solar Inverter Series ES - Effekta

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?