1 Prosthetics - Orto Finland

3 Materials
3.6 Tools
3.1 Plaster Fabrication
Materials
Vacuum Forming System
The vacuum-forming system has been designed for the blister vacuum-forming of transtibial and transfemoral prosthetic positive models.
It consists of aholding frame and two holding frame plates, one for transfemoral (large opening, Ø 320 mm), and one for transtibial prostheses
(small opening, Ø 265 mm).
Order No. Inside dimension / mm Article No.
WZ156 265/320 4 340 010 00 00 000
3.2 Lamination
Materials
3.3 Plastic Sheet
Materials
1
3
7
3.4 Padding Materials
4
2a
2
8
9
3.5 Other Materials
9
10
12
3.6 Tools
6
5
11
Order No. Description Ø / mm Article No. Pict.
E-WZ62 Holding frame 265/320 4 340 011 01 00 000 1
E-WZ63 Vacuum forming disk unit, compl. 265/320 4 340 011 02 00 000 2
E-WZ64 ipocon Ring 270 4 340 011 03 00 000 3
E-WZ65 Holding frame plate 265 4 340 011 04 00 265 4
E-WZ66 Holding frame plate 320 4 340 011 04 00 320 as 4
E-WZ50 Bench-top vise supporter 4 339 011 05 00 000 5
E-WZ51 Double-pylon clamp vise, complete 4 339 011 06 00 000 6
E-WZ67 Clamping lever for double pylon clamp vise M12 (handle only) 4 340 011 05 00 000 7
E-WZ68 Supporter for holding frame, 200 mm length 4 340 011 06 00 000 8
E-WZ69 Handle screw for holding frame, 1 pc. 4 340 011 07 00 000 10
E-WZ70 Handle screw for holding frame, 4 pc. 4 340 011 08 00 000 9
E-WZ71 Foot control valve vacuum forming system 4 340 011 09 00 000 11
E-WZ72 Cylinder screw M6 x 14 4 340 011 10 00 000 12
E-WZ73 Disk Ø 10.5 4 340 011 11 00 000 no pict.
E-WZ74 Retrofitting set for vacuum forming disk 4 340 011 12 00 000 no pict.
E-WZ75 Vacuum forming disk, incl. ipocon ring and vertical rod 4 340 011 13 00 000 2 a
E-WZ76 PE supporter, Ø = 290 mm 4 340 011 14 00 000 no pict.
175