T-51750GD065J-FW-ADN - OLED-LCD-TFT

5. Test
No change on display and in operation under the following test condition.
Conditions: Unless otherwise specified, tests will be conducted under the following condition.
Temperature: 20±5°C
Humidity : 65±5%RH
tests will be not conducted under functioning state.
No. Parameter Conditions Notes
1 High Temperature Operating 60°C, 96hrs (operation state)
2 High Temperature Storage 85°C, 96hrs 2
3 Low Temperature Storage -25°C, 96hrs 1,2
4 Damp Proof Test 40°C,90~95%RH, 96hrs 1,2
5 Vibration Test Frequency:10-57Hz/Vibration width(one side):0.75mm 3
:58-500Hz/Gravity:9.8m/s 2
Sweep time:11minutes
6 Shock Shock level:490m/s 2
Test period:3hrs for each direction of X,Y,Z
Waveform:half sinusoidal wave, 11ms
Number of shocks :
One shock input in each direction of three mutually
perpendicular axis for a total of six shock inputs
7 Shock Test To be measured after dropping from 60cm high on
Note 1: No dew condensation to be observed.
the concrete surface in packing state.
Note 2: The function test shall be conducted after 4 hours storage at the normal
Temperature and humidity after removed from the test chamber.
Note 3: Vibration test will be conducted to the product itself without putting it in a container.
E
B
T-51750GD065J-FW-ADN (AD) No. 2005-0498 OPTREX CORPORATION Page 18/24
G D
60cm
A
F
C
Concrete Surface
Dropping method corner dropping
A corner : once
Edge dropping
B,C,D edge : once
Face dropping
E,F,G face : once