Your Partner in terms of Drying - Eberl Trocknungsanlagen Gmbh

More documents

Recommendations

Info

is a used insulating container with a lining that has been varnished in white aluminium RAL 9006. The interior consists of an aluminium section floor, the walls are made of stainless steel. There are four locking rods at the two-winged door. The containers having lengths of 6m and 12m are available in different stages of expansion: ● As heat treatment container HC6 or HC12 For heat treatment purposes for packaging wood according to IPPC standard ISPM No. 15 only ● As heat treatment container with dehumidification option HC6E or HC12E For heat treatments and manually controlled drying procedures ● As drying container TC6 or TC12 In order to dry and steam different types of wood and obviously for heat treatments ● Compact system with extraordinary insulation. ● Uniform ventilation due to ideal arrangement of the fans and sufficiently dimensioned space for circulating air. ● Variable partition walls and a rubber flashing in order to avoid air short circuits. ● Lower energy consumption and good dehumidification performance due to positioning the exhaust air fan and the inlet air flaps ideally.
is located at the tower immediately next to the energy-efficient fans. It is available as hot water heating register and/or as electronic heating system. The drying system can also be operated using a heat pump. is suitable for using the exhaust heat of CHP, biological gas plants, or other aggregates. Drying procedures and/or heat treatments of trimmed timber of all types, pallets, boxes, firewood, or any similar types of wood are possible. obviously can also be installed into existing buildings or chambers and are available as adjusted assembly with EBERL. A PLC from Siemens controls the whole drying procedure. Having more than 50 programmes for steaming, heat treatments, and drying of the most different types of wood, the climate in the chamber is monitored, controlled, and logged in dependency of the degree of humidity of the corresponding wood. The visualisation allows for starting and monitoring the drying procedure and for printing out protocols comfortably from the office. This also provides for the possibility of monitoring the drying procedure from home. The drying procedure/heat treatment is logged on the memory card and/or a printer and meets all provisions of the ISPM No. 15. The heat treatment is implemented in accordance with the provisions of the ISPM No. 15 Germany. In doing so, the wood core temperature is brought to 56°C and this temperature is maintained for half an hour.
Page 1: Your Partner in terms of Drying cos

Your Partner in terms of Drying - Eberl Trocknungsanlagen Gmbh

Create successful ePaper yourself

Delete template?

Save as template?