WATTS 150A Water Hammer Arrestor WATTS ... - Watts Industries
WATTS 150A Water Hammer Arrestor WATTS ... - Watts Industries
WATTS 150A Water Hammer Arrestor WATTS ... - Watts Industries
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>WATTS</strong> <strong>150A</strong><br />
2<br />
What is water hammer?<br />
<strong>Water</strong> hammer (which often sounds as if the water pipes are being ‘hammered’) is caused<br />
by the sudden deceleration of a column of moving water, which converts the kinetic energy<br />
into a pressure that may reach extremely high values. The problem usually occurs when the<br />
water fl ow is suddenly cut off by fast closing valves, which can be found in all kinds of waterconsuming<br />
machines and appliances. The water tries to fi nd a balance in the main water<br />
system. Dish washing machines, washing machines and taps that are suddenly closed may<br />
cause water hammer. This is accompanied by the annoying sound of banging, rattling pipes,<br />
but there is also a risk of leaking pipe joints or damage to appliances.<br />
Installation instruction<br />
• Install the water hammer arrestor as close as possible to the source of shock.<br />
• Use the right tools to mount the arrestor to prevent damage.<br />
• The factory pre-charged pressure is 2 bar. If the system pressure is higher than<br />
2.5 bar, you can add pressure (air) (auto valve at the top) up to a maximum of 0.5 bar<br />
below this system pressure.<br />
• The maximum operating pressure is 10.5 bar.<br />
• PLEASE NOTE: Never press the valve.<br />
This will cause the arrestor to lose its damping capacity.<br />
Installation examples<br />
Dish washing machines<br />
Washing machines<br />
Quick closing faucets<br />
112 mm<br />
ø 86 mm