Modern Orgone - Transkommunikation.ch

Chembuster will not behave the same as a normal
Chembuster, and may not be useful in a passive
role.
The central cavity runs through the entire axial
length of the Chembuster base, in the spot where a
center pipe would go if you were using a center
pipe. I would suggest that you start with the vial
placed as shown in the schematics and experiment
with that for a while. If the desired results are not
achieved, substitute the vial with a good quality
piece of quartz and place the vial either directly
above or below the quartz piece (see schematics).
Mobius Coil(s)
There are several ways the Mobius coils could be
integrated with the device. I have put some thought
into it and given you what I think is the best for
your application, and which would give you the
most configurability for experimentation.
The idea i have involves several Mobius coils,
installed in both the Orgone Matrix Material base
and on the ends of the pipes.
http://www.keelynet.com/
"The West won the world not by
the superiority of its ideas or
values or religion but rather by its
superiority in applying organized
violence. Westerners often forget
this fact, non-Westerners never
do."
-Samuel Huntington, Harvard Professor, "The
Clash of Civilizations"
Large Coils
First, make a large Mobius coil with a diameter
sized to just fit over the innermost (highest density)
layer of the CaDens layers in the base of the CB.
Ideally, this coil should have several hundred feet
of wire but it is difficult to do the winding in the
toroidal fashion with wire lengths in excess of 100
feet. It may still be done with a helper to assist in
handling the cable as you loop it through the center
of the coil, or several cables may be made and
connected in series to form a longer coil.Set this
first coil aside and make another the same, but in
the exact opposite orientation of the first (twist the
cable in the opposite direction and wind the coil in
the opposite direction). When you are done, you
should have two coils that have the same diameter
(sized to fit over the innermost CaDens layer) and
are MIRROR IMAGES OF EACH OTHER. Cut a
thin spacer of some dielectric material such as
poster-board or phenolic sheet and fasten the two
coils to the spacer with a little glue. Then, wrap
electrical tape around the two coils like you wound
the cable so that the finished unit is covered entirely
with electrical tape. Last, wrap a single layer of
aluminum tape or copper foil around the large coil
assembly so that it covers the outer periphery of the
assembly but does not cover the inner diameter of
the assembly. See attached schematics. Once
constructed, set the two large coil assembly aside.
48