Tata Sumo Victa Owner's Manual & Service Book - Tata Motors ...
Tata Sumo Victa Owner's Manual & Service Book - Tata Motors ...
Tata Sumo Victa Owner's Manual & Service Book - Tata Motors ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
COMBINATION SWITCH & TURN SIGNALS<br />
HANDLING<br />
HANDLING<br />
COMBINATION SWITCH & LIGHTS<br />
Steering is provided with steering lock cum ignition switch<br />
to lock steering while parking the vehicle as safety against<br />
theft.<br />
to start and stop the engine.<br />
to switch on and off the electrical system other than listed<br />
below.<br />
Horn, parking lamps, engine inspection lamp and hazard<br />
warning indicators are not connected through this switch and<br />
operate independently.<br />
to switch on and off the accessories only.<br />
The switch is located on the steering column support and has<br />
the following key positions:<br />
LOCK<br />
Key can be inserted or taken out only in this position. Steering gets<br />
locked only after the key is withdrawn from the switch.<br />
After withdrawing the key from the switch ensure that steering is<br />
locked by turning steering wheel clockwise and anticlockwise.<br />
To unlock the steering, insert the key into the switch and turn it<br />
clockwise. If any difficulty arises in unlocking turn the steering<br />
wheel a little clockwise or anticlockwise while turning the key.<br />
ACC<br />
By turning the key to ‘ACC’ position power supply to accessories is<br />
switched on.<br />
ON<br />
By turning the key to this position all remaining electrical systems<br />
become operative and lamps of battery charging indicator, low oil<br />
pressure will come on.<br />
In ‘ON’ position, the glow plug controller switches on the glow plugs<br />
and glow indicator lights up. After a few seconds, depending on the<br />
ambient temperature, the indicator light only goes off indicating<br />
that the engine can be started. Glow plugs remain on for few<br />
seconds and switches off automatically.<br />
As a safety feature glow plugs are automatically switched off after a<br />
lapse of certain time if the engine is not started to conserve battery.<br />
In this case to start the engine repeat the operation by first going to<br />
‘ACC’ or ‘LOCK’ position.<br />
START<br />
Turn the key further clockwise to start position (spring loaded) to<br />
operate starter motor. As soon as the engine starts release the<br />
ignition key, so that key can come back to ‘ON’ position and starter<br />
motor disengages and glow plug is switched off. Vehicle is driven in<br />
this position. By turning the ignition key from ‘ON’ position to ‘ACC’<br />
or ‘LOCK’ position engine can be stopped.<br />
WIPER STALK<br />
FLICK WIPE<br />
SPRING RETURN<br />
OFF<br />
FAST WIPE<br />
SLOW WIPE<br />
PUSH SWITCH<br />
FOR WASH & WIPE<br />
OFF<br />
INT. WIPE<br />
MAX.<br />
DELAY TIMING FOR<br />
INTERMITTENT WIPE<br />
MIN.<br />
Combi-switch<br />
OFF<br />
LIGHT STALK<br />
FLASH HIGH BEAM<br />
SPRING RETURN<br />
DIP BEAM<br />
(NORMAL POSITION)<br />
HIGH BEAM<br />
LEFT TURN<br />
(SIGNAL SELF CANCELLING)<br />
LANE CHANGE LEFT (SPRING<br />
OFF<br />
LANE CHANGE RIGHT (SPRING RETURN)<br />
RIGHT TURN<br />
(SIGNAL SELF CANCELLING)<br />
LIGHTS CONTROL SWITCH<br />
30<br />
31