THE MANUAL: AURORA CDD - the Solar Panel Store

More documents

Recommendations

Info

Page 15 of 80 Instruction Manual for AURORA CDD BCG.00613_AA Part 2 Unpack and Select Installation Location 2.2 SELECT INSTALLATION LOCATION The device uses radio waves to transmit and receive data, it is therefore important to assess this factor in choosing the installation position. Walls in reinforced cement and surfaces covered in metal (doors, shutters, etc.) can markedly reduce the reach of the device as noted below. Table 2-2: Factors affecting wireless signal strength Material Relative signal range reductions Open Field Approximately 100 m Wood / Glass 0 – 10% Stone / Pressed cardboard 10 – 40% Reinforced concrete increases with amount of 10 – 90% reinforcement Metal Up to 100% It is advisable to undertake all the configuration operations, before installing the CDD permanently in the same location and position used during the configuration. 2.2.1.1 Overall Dimensions The following figure shows the overall dimensions expressed in mm and in inches. Figure 2-1: Overall Dimensions
Page 16 of 80 Instruction Manual for AURORA CDD BCG.00613_AA Part 2 Unpack and Select Installation Location 2.2.1.2 Point the Radio Antenna In order to boost the signal strength, point the antenna of the CDD in a parallel line to the MICRO Inverters as shown below. Figure 2-2: Optimal CDD signal strength When configuring the CDD (see Part 3), it may be necessary to adjust the positioning of the antenna.
Page 1 and 2: THE MANUAL: AURORA CDD
Page 3 and 4: Page 2 of 80 Instruction Manual for
Page 11 and 12: Page 10 of 80 Instruction Manual fo
Page 15: Page 14 of 80 Instruction Manual fo
Page 67 and 68:
Page 66 of 80 Instruction Manual fo
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
show all

THE MANUAL: AURORA CDD - the Solar Panel Store

Create successful ePaper yourself

Delete template?

Save as template?