THE MANUAL: AURORA CDD - the Solar Panel Store

More documents

Recommendations

Info

Page 37 of 80 Instruction Manual for AURORA CDD BCG.00613_AA Part 4 Operations Guide There is no timeout for the acquisition procedure. Press STOP ACQUISITION when all the MICRO Inverters have been found. Upon completion, a list of the MICRO Inverters will be displayed and include the MAC RF (MAC Radio Frequency Address), SN (Serial Number) and Signal (radio signal quality indicator) for each inverter found.
Page 38 of 80 Instruction Manual for AURORA CDD BCG.00613_AA Part 4 Operations Guide In this example five MICRO Inverters have been found. Select the MICRO Inverters to be associated with the CDD (or deselect using the check box) and press CONFIRM. During acquisition of the system the installer must check that all the MICRO Inverters installed have been recognized successfully. This can be done by comparing the MAC addresses detected with the ones indicated on the cover or the carrier box of each inverter, or using the system map created with the removable adhesive labels. MICRO Inverters with a signal less than 25 should not be assigned, as they would be too weak. In this case it is necessary to assess whether to install the CDD in a new position or to use a signal repeater (REP). If the MICRO Inverter has the Serial Number xxxxxx this means that the CDD has not yet acquired the Serial Number for that MICRO Inverter. Wait a few minutes and then repeat the scan by going back to the Configuration menu and selecting Start Acquisition.
Page 1 and 2: THE MANUAL: AURORA CDD
Page 3 and 4: Page 2 of 80 Instruction Manual for
Page 11 and 12: Page 10 of 80 Instruction Manual fo
Page 37: Page 36 of 80 Instruction Manual fo

THE MANUAL: AURORA CDD - the Solar Panel Store

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?