BTD52L Thermodynamic Steam Trap - Spirax Sarco

More documents

Recommendations

Info

1 General safety information Safe operation of these units can only be guaranteed if they are properly installed, commissioned and maintained by a qualified person (see Secton 11 of the attached Supplementary Safety Information) in compliance with the operating instructions. General installation and safety instructions for pipeline and plant construction, as well as the proper use of tools and safety equipment must also be complied with. Isolation Consider whether closing isolating valves will put any other part of the system or personnel at risk. Dangers might include: isolation of vents and protective devices or alarms. Ensure isolation valves are turned off in a gradual way to avoid system shocks. Pressure Before attempting any maintenance consider what is or may have been in the pipeline. Ensure that any pressure is isolated and safely vented to atmospheric pressure before attempting to maintain the product, this is easily achieved by fitting Spirax Sarco depressurisation valves type DV (see separate literature for details). Do not assume that the system is depressurised even when a pressure gauge indicates zero. Temperature Allow time for temperature to normalise after isolation to avoid the danger of burns and consider whether protective clothing (including safety glasses) if required. Disposal These products are recyclable. No ecological hazard is anticipated with the disposal of these products providing due care is taken. 2 IM-P181-03 ST Issue 4
2 General product information 2.1 General description The BTD52L is manufactured from 316L stainless steel specifically for mains drainage applications in clean steam systems. Optional extras An insulating cover is available at extra cost to prevent the trap being unduly influenced by excessive heat loss when subjected to low ambient temperature, wind and rain etc. Note: For additional information see Technical Information Sheet TI-P181-01. 2.2 Sizes and pipe connections ¼", 3 /8", ½" screwed BSP or NPT. ½" O/D x 16 swg (0.065") wall thickness tube end. DN 11850 (Series 1) tube ends 12 mm O/D x 1.0 mm wall thickness (DN10) 18 mm O/D x 1.0 mm wall thickness (DN15) ISO 1127 (Series 1) tube ends 17.2 mm O/D x 1.6 mm wall thickness (DN10) 21.3 mm O/D x 1.6 mm wall thickness (DN15) ½" Sanitary clamp compatible connections (DN15) Fig. 2 ½" Tube ends Fig. 1 Screwed Fig. 3 Sanitary clamp ends IM-P181-03 ST Issue 4 3
Page 1: 1810050/4 IM-P181-03 ST Issue 4 BTD
Page 5 and 6: 3 Installation Note: Before actioni
Page 7 and 8: 7 Spare parts The spare parts avail

BTD52L Thermodynamic Steam Trap - Spirax Sarco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?