Design Of Digital Circuits - Dharmsinh Desai University

Design Of Digital Circuits Lab Manual
3.3 Implementing the Solution
Plug the chips you will be using into the breadboard. Point all the chips in the same direction with pin
1 at the upper-left corner. (Pin 1 is often identified by a dot or a notch next to it on the chip package).
Connect +5V and GND pins of each chip to the power and ground bus strips on the breadboard.
Make the connections as per the circuit diagram.
Switch on VCC and apply various combinations of input according to truth table.
Derive your conclusion.
3.4 Testing the Solution:
Observation table for example:
INPUT
OUTPUT
A B C D Y Y’
1 × × ×
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
0 1 1 0
0 1 1 1
4 Conclusions
We can conclude that to implement any function we can use multiplexer.
Department of Information Technology, Faculty of Technology, D. D. University, Nadiad.
35