Palette Programming Tips and Tricks #9 - Strand Lighting

More documents

Recommendations

Info

Independent Timing on Attributes Not only can independent timing be assigned to intensity levels but to attributes as well. The image above shows and example of fixtures 1 thru 10 being Vari*Lites, independent timing has been assigned to pan and tilt with the following commands… CL: [1] [THRU] [10] [S2-Pan] [6] [ENTER] CL: [S3-TIlt] [12] [ENTER] Once that has been set, Updating the cue will store this information. Note: I had not only patched the 10 Vari*Lites, I also move them and updated the cue so that the cue had instructions on the pan and tilt values for the selected fixtures. Without a level instruction, there is no need for timing info. Based on PaletteOS 10.8.4 6
Ranging Values A very nice shortcut is to be able to range values across the selected channels. The above image shows 20 fixtures all starting at the same time but taking a little longer on each fixture. CL: [1] [THRU] [20] [@] [0] [-] [3] [ENTER] Note: Remember that 1 thru 20 need to have a change of level or independent timing won’t apply. Also, use the minus “-“ key for the “to” command after you enter the starting value. Based on PaletteOS 10.8.4 7
Page 1 and 2: Welcome to Palette Programming Tips
Page 3 and 4: The Interface I’ll create a simpl
Page 5: Once the cue is updated, notice tha
Page 9 and 10: Ranging Values with Relative Data I
Page 11: Palette iRFU I want to replace the

Palette Programming Tips and Tricks #9 - Strand Lighting

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?