Sika Florseal WB 18 MSDS - Brock White

Sika Canada Inc.
MATERIAL SAFETY DATA SHEET
Page 1 of 5
SECTION I: PRODUCT INFORMATION
PRODUCT: Sika ® Florseal ® WB-18 REVISION DATE: February 1 st , 2012
USAGE:
WATER-BASED ACRYLIC CURING AND SEALING COMPOUND
MANUFACTURER/SUPPLIER: SIKA CANADA INC.
601, avenue Delmar
Pointe Claire, QC
H9R 4A9
EMERGENCY TELEPHONE NUMBER: CANUTEC (collect) (613) 996-6666
TDG CLASSIFICATION: Not Regulated WHMIS Classification: Not Regulated
UN NUMBER: Not Applicable Class: Not Applicable
Packaging Group: Not Applicable
SECTION II: HAZARDOUS INGREDIENTS
Hazardous ingredients % T.L.V. # CAS
NONE
LD 50 (mg/kg)
(species, route)
LC 50
(species, route)
SECTION III: PHYSICAL CHARACTERISTICS
Physical State: Liquid
Appearance and Odor: Milky white with a slight odor
Odor Threshold: Not Established
Evaporation Rate: Similar to water
Vapor Density: Water
Vapor Pressure: 25 mm/Hg
Boiling Point: 100ºC
Freezing Point: 0ºC
Density: 1.02 g/cm 3 (H 2 O = 1)
Water Solubility: 100%
pH:
Not Available
% volatile: Not Established
Water/Oil Distribution: Not Established

Sika Canada Inc.
MATERIAL SAFETY DATA SHEET
Page 2 of 5
PRODUCT:
Sika ® Florseal ® WB-18
SECTION IV: FIRE AND EXPLOSION HAZARDS
Flammability:
If Yes, under what conditions:
Extinguishing methods:
No
Water spray
TDG inflammability Class:
Flammable upper limits (% vol.):
Flammable lower limits (% vol.):
Flash Point (method used):
Auto-ignition temperature:
Dangerous Combustion Products:
Not Regulated
Not Established
Not Established
121ºC (Closed cup)
Not Available
Carbon oxides
Special Methods:
None. This material is
water based. Use
water spray to protect
fire-fighters. If water is
to be used, use a fog
nozzle to cool closed
containers. Avoid
spraying directly into
open containers to
prevent boilover.
Protect from mechanical impact:
Protect from static discharge:
Not Established
Not Established
SECTION V: REACTIVITY DATA
Chemical stability:
Yes
Dangerous decomposition products:
Carbon oxides
If not, under what conditions
Incompatibility with other material:
Yes
Polymerization Risks:
Will not occur
If Yes, which ones:
Strong
oxidizers

Sika Canada Inc.
MATERIAL SAFETY DATA SHEET
Page 3 of 5
PRODUCT:
Sika ® Florseal ® WB-18
SECTION VI: TOXIC PROPERTIES
ROUTE OF ENTRY / CONTACT
Eyes:
Can cause severe irritation, redness,
tearing, and blurred vision.
Carcinogenicity:
Not Established
Skin:
Prolonged or repeated contact can
cause irritation to persons with
sensitive skin.
Toxic effects
on reproduction:
Teratogenicity:
Not Established
Not Established
Inhalation:
Ingestion:
Excessive inhalation of vapors can
cause irritation to mucous membrane,
respiratory irritation, dizziness, and
headache.
Can cause gastrointestinal irritation,
nausea, vomiting and diarrhea.
Aspiration of material into the lungs
can cause chemical pneumonia which
can be fatal.
Mutagenicity:
Product with synergistic
effects:
Not Established
Not Established
An acute or chronic exposure will increase the toxic effects mentioned in this section and may aggravate chronic
respiratory conditions, eye disease, skin disorders and allergies.

Sika Canada Inc.
MATERIAL SAFETY DATA SHEET
Page 4 of 5
PRODUCT:
Sika ® Florseal ® WB-18
SECTION VII: PREVENTIVE MEASURES
PERSONAL PROTECTIVE EQUIPMENT
OTHERS
Gloves:
Use chemical resistant gloves
Respiratory equipment: Use a properly fitted NIOSHapproved
respirator where the
TLV is exceeded
Eyes:
Shoes:
Clothing:
Safety glasses
Leather
Lab coat
Ventilation:
Procedure in case
of leaks:
Sufficient ventilation required.
Provide general or local exhaust
ventilation systems to maintain clean
air.
Absorb with sand or other absorbent
material and transfer into suitable
containers. Flush immediately with
water (prevent water from entering
waterways).
Other:
Eye wash station, shower
Handling and Equipment
methods:
Avoid skin and eye contact. Use only
in well ventilated areas. Wash after
using and before eating or drinking.
Avoid breathing vapors.
Warehouse
Requirements:
Special Shipping
Instructions:
Waste Disposal:
Keep all containers closed in a cool
and dry area.
See TDG class
Dispose of sand and rinse water
according to municipal, provincial or
federal laws for disposal of
chemicals. Do not allow product to
reach ground water, water course or
sewage system, even in small
quantities.

Sika Canada Inc.
MATERIAL SAFETY DATA SHEET
Page 5 of 5
PRODUCT:
Sika ® Florseal ® WB-18
SECTION VIII: FIRST AID
Skin:
Remove contaminated clothing as soon as possible.
Wash exposed skin thoroughly with soap and water.
Wash contaminated clothing before reuse.
Extremely contaminated leather shoes should be discarded.
Consult a physician if irritation persists.
Eyes:
Rinse eyes with plenty of water for at least 15 minutes, while holding eyelids wide
open, to ensure a proper wash.
See a physician immediately.
Inhalation:
In the case of overexposure, evacuate to fresh air.
If not breathing, give artificial respiration.
Consult a physician immediately.
Ingestion:
Do not induce vomiting.
Do not give anything by mouth to an unconscious person.
Should vomiting occur, be sure to keep victim’s head below hips to avoid aspiration of
vomit into the lungs.
See a physician immediately.
SECTION IX: PREPARATION INFORMATION
Prepared By:
The Laboratory, Research and Development Department of Sika Canada Inc.
Telephone #: (514) 697-2610
Fax #: (514) 694-2792
Notice To Reader
The information contained in this Material Safety Data Sheet applies only to the actual Sika Canada product identified and described herein. This
information is not intended to address, nor does it address the use or application of the identified Sika product in combination with any other material,
product or process. All of the information set forth herein is based on technical data regarding the identified product that Sika believes to be reliable
as of the date hereof. Prior to each use of any Sika product, the user must always read and follow the warnings and instructions on the product's
current Product Data Sheet, product label and Material Safety Data Sheet for each Sika product, which are available at web site and/or telephone
number listed in Section IX of this MSDS.
SIKA MAKES NO WARRANTIES EXPRESS OR IMPLIED AND ASSUMES NO LIABILITY ARISING FROM THIS INFORMATION OR ITS USE.
SIKA SHALL NOT BE LIABLE UNDER ANY LEGAL THEORY FOR SPECIAL OR CONSEQUENTIAL DAMAGES AND SHALL NOT BE
RESPONSIBLE FOR THE USE OF THIS PRODUCT IN A MANNER TO INFRINGE ON ANY PATENT OR ANY OTHER INTELLECTUAL
PROPERTY RIGHTS HELD BY OTHERS.
All sales of Sika products are subject to its current terms and conditions of sale available at www.sika.ca or 514-697-2610.
AQ 191 A
Date: 2012/02/01
App: S.G.