Coated and Non-Woven Abrasives - Pferd

POLICAP
General Information
Safety Recommendations
POLICAP abrasive caps and cones are mounted
on reusable cap and cone holders.
Due to their seamless design, POLICAP
abrasive caps and cones grind effectively with
their entire surface area. A closely toleranced fit
keeps the abrasive cap or cone securely attached
to its holder.
PFERD supplies POLICAP tools in diverse
shapes, dimensions and grit sizes.
Advantages
■■The PFERD range comprises an extensive
selection of POLICAP abrasive caps and
cones.
■■Cap and cone holders are fully reusable.
■■Slots in the holder facilitate its expansion,
locking the tool firmly in place.
■■The special manufacturing process guarantees
good shapeholding and excellent fine grinding
properties.
■■Easy tool replacement.
Application Examples
■■Fine grinding in tool, die and mold-making
applications.
■■Grinding in hard-to-reach areas and bores.
= Wear protective goggles! = Use ear protection!
Recommendations for Use
■■Abrasive caps and cones are mounted and
removed with a slight clockwise twist.
■■Abrasive caps and cones are easier to replace
with the holder mounted on the power tool.
■■Abrasive cones perform best at a recommended
peripheral speed of 2,000 -
4,000 SFPM.
Safety Notes
■■The maximum approved peripheral speed is
5,000 SFPM.
■■For safety reasons, never exceed listed maximum
RPM’s.
Dust Warning
Use of the tools in this catalogue may create
dust and other particles. To avoid any risk of
adverse health effects, the operator must use
appropriate protective measures, including
a respirator, during and after tool operation.
Refer to our Material Safety Data Sheet (MSDS)
for further information regarding the product to
be used. Furthermore, additional health hazards
may result from dust in the surrounding environment
and from dust generated from the work
piece material. PROTECTIVE MEASURES FOR THE
OPERATOR MUST ADDRESS DUST AND OTHER
PARTICULATES ARISING FROM ALL SOURCES.
Always use our products in a well-ventilated
workspace.
204
= Wear a respirator!
= Wear protective gloves!
= Observe safety recommendations!
Read the Material Safety Data
MSDS
= Sheets (MSDS) before using any
materials!
Peripheral Speed of
POLICAP Tools
In the diagram, peripheral speeds are represented
by blue diagonal lines. Each vertical
line represents a tool diameter. From its point of
intersection with the diagonal line for a given
peripheral speed, proceed horizontally to the left
margin where you will find the corresponding
rotational speed [RPM] of the POLICAP tool
and machine spindle.
Example:
Shape A
Diameter 3/8”
EDP: 42010 (holder), 46036 (cap)
Peripheral Speed: 2,000 - 4,000 SFPM
Rotational Speed: 19,000 - 38,000 RPM
Rotational Speed [RPM]
Tool Diameter [Inches]
CATALOGUE
204 I
PAGE
49