Coated and Non-Woven Abrasives - Pferd

Grinding and Polishing Pastes
Polishing Pastes
These pastes are designed for work on very
hard materials, e.g. tungsten carbide and heattreated
steels. They are used with felt points or
felt wheels.
The high concentration of abrasive grain guarantees
fast and efficient results.
Available Grit Sizes
30 = Coarse
15 = Medium
7 = Fine
3 = Very Fine
Recommendation for Use
The selection of the appropriate grit size will essentially
depend on the required surface finish.
When working with diamond polishing paste, it
is recommended to start with the coarsest grit.
Where major surface improvements have to be
achieved, use several grits of increasing fineness
in successive steps and clean the workpiece
thoroughly after each passed step. Always use
a new, clean tool (e.g., felt point, felt wheel)
before switching to finer grit.
Ordering Note
Grit sizes are indicated in µm.
PFERD Specification Number
DPP
Diamond Polishing Pastes
Grit Size
[µm]
EDP Number Content Cap Colour
[oz]
[grams]
30 48751 0.18 5 Brown 1
30 48750 0.70 20 Brown 1
15 48753 0.18 5 Blue 1
15 48752 0.70 20 Blue 1
7 48755 0.18 5 Red 1
7 48754 0.70 20 Red 1
3 48757 0.18 5 Green 1
3 48756 0.70 20 Green 1
Used to maintain a constant lubrication layer
between the tool and the workpiece in polishing
applications.
Recommendation for Use
The diluting preparation should be used
extremely sparingly. Excessive use will wash out
diamond grain from the paste, thus diminishing
polishing performance.
PFERD Specification Number
PSP
Special Diluting Preparation
for Diamond Polishing Pastes
204
EDP Number
[oz]
Content
[ml]
48758 4.41 125 1
CATALOGUE
204 I
PAGE
95