AMUT-BD AUDIO MONITORING UNIT - TSL
AMUT-BD AUDIO MONITORING UNIT - TSL
AMUT-BD AUDIO MONITORING UNIT - TSL
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
7.1 Initial Set-Up<br />
Connect 1khz Tone @ 0dB to Analogue I/P 1 L & R.<br />
Set front panel switches to Analogue I/P 1 , check for audio presence indication on<br />
front panel LEDs and deflection on both meters .<br />
7.2 Audio Alignment AMP-2<br />
The board is set for unity gain.<br />
Place the AMP-2 PCB on an extender card.<br />
PR1 is set for the LH A1 channel 0dB O/P probe pins C10/C11- balanced.<br />
PR2 is set for the RH A2 channel 0dB O/P probe pins C12/C13 – balanced.<br />
PR5 is set for 0db for the fixed A3 channel probe pins C14/C15 – balanced.<br />
PR6 is set for 0dB for the fixed A4 channel probe pins C16/C17 – balanced.<br />
PR3 is set for 0dB for the S signal probe pin C1.<br />
PR4 is set for 0dB for the M signal probe pin C1.<br />
PR7 is the LH PPM drive output and is set for 0dB probe pin C24.<br />
PR8 is the RH PPM drive signal and is set for 0dB probe pin C25.<br />
7.3 Bargraph Calibration Procedure<br />
Factory Setting.<br />
8.0 General Notes<br />
1. Set the ADX-1 card for the desired reference level with AES/EBU<br />
and/or SDV I/P signals.<br />
2. Please note that some American equipment has the function of the<br />
XLR pins 2 & 3 reversed.<br />
<strong>TSL</strong> product is wired to the European standard<br />
<strong>AMUT</strong>-<strong>BD</strong> MKII 22 ISSUE 5
Change language