Press the - Pentax

More documents

Recommendations

Info

2 Caution • Do not short the batteries or dispose of the batteries in fire. Do not disassemble the batteries. The batteries could explode or catch fire. • Do not charge any batteries other than rechargeable Ni-MH batteries. The batteries could explode or catch fire. Of the batteries that can be used in this camera, only the Ni-MH batteries can be recharged. • Remove the batteries from the camera immediately if they become hot or begin to smoke. Be careful not to burn yourself during removal. • Some portions of the camera heat up during use. There is the risk of low temperature burns when holding such portions for long periods. • Do not place your finger over or cover the flash with clothing when discharging the flash. Fingers or clothing may be burned. PRECAUTIONS FOR BATTERY USAGE • Only use specified batteries with this camera. Use of other batteries can cause a fire or explosion. • Replace the batteries at the same time. Do not mix battery brands, type or an old battery with a new one. It may cause explosion or a fire. • The batteries should be inserted correctly with regard to polarity (+ and –) marked on the batteries and the camera. Not inserting batteries correctly may cause explosion or a fire. • AA lithium batteries, AA alkaline batteries and disposable CR-V3 are not rechargeable. Do not disassemble the batteries. Recharging and disassembling can cause explosion or leakage. Care to be Taken During Handling • Take the Worldwide Service Network that is included in the package. This will be useful if you experience problems abroad. • When the camera has not been used for a long time, confirm that it is still working properly, particularly prior to taking important pictures (such as at a wedding or during traveling). Pictures cannot be guaranteed if recording, playback or transferring your data to a computer, etc. is not possible due to a malfunction of your camera or recording media (SD Memory Card), etc. • Do not clean the product with organic solvents such as thinner or alcohol benzene. • Do not subject to high temperatures or high humidity. Do not leave the camera in a vehicle, as the temperature can get very high.
• Do not store the camera with preservatives and chemicals. Storage in high temperatures and high humidity can cause molding. Remove from case and store in a dry and well-ventilated location. • This camera is not waterproof, and should not be used in the rain or where the camera could get wet. • Do not subject the camera to strong vibrations, shocks, or pressure. Use a cushion to protect the camera from vibrations of motorcycles, automobiles, or ships. • The temperature range for camera use is 0°C to 40°C (32°F to 104°F). • The LCD display may appear black under high temperatures, but will return to normal as temperatures normalize. • The LCD display may respond more slowly at low temperatures. This is due to liquid crystal properties, and is not a fault. • Periodic inspections are recommended every one to two years to maintain high performance. • Sudden temperature changes will cause condensation on the inside and outside of the camera. Place the camera in your bag or a plastic bag, removing the camera after temperature of the camera and surroundings are equalized. • Avoid contact with garbage, mud, sand, dust, water, toxic gases, or salts. These could cause a camera breakdown. Wipe dry any rain or water drops on the camera. • Refer to “Precautions When Using the SD Memory Card” (p.30) regarding the SD Memory Card. • Use a lens brush to remove dust accumulated on the lens or viewfinder. Never use a spray blower for cleaning as it may damage the lens. • Please do not press forcefully on the LCD monitor. This could cause breakage or malfunction. 3 Regarding Product Registration In order to better service you, we request that you complete the product registration, which can be found on the CD-ROM supplied with the camera or the PENTAX website. Thank you for your cooperation. Refer to the PENTAX PHOTO Browser 2.1/PENTAX PHOTO Laboratory 2.1 Operating Manual (Windows users: p.10, Mac OS users: p.12) for more information.
Page 1 and 2: SLR Digital Camera Operating Manual
Page 3: FOR SAFE USE OF YOUR CAMERA 1 We ha
Page 7 and 8: Basic Operations 41 5 Basic Shootin
Page 9 and 10: Checking the Composition, Exposure
Page 11 and 12: Composition of the Operating Manual
Page 13 and 14: 1 Before Using Your Camera Check th
Page 15 and 16: Checking the Contents of the Packag
Page 17 and 18: 15 K button Mode dial Strap lug Cab
Page 19 and 20: Capture Mode 17 Press the M button
Page 21 and 22: Histogram Display 19 1 2 100-0046 3
Page 23 and 24: 10 EV compensation (p.142) Appears
Page 25 and 26: 2 Getting Started This chapter expl
Page 27 and 28: Inserting the Batteries 25 Insert b
Page 29 and 30: Battery Level Indicator 27 You can
Page 31 and 32: Inserting/Removing the SD Memory Ca
Page 33 and 34: Recorded Pixels and Quality Level C
Page 35 and 36: Initial Settings 33 The first time
Page 37 and 38: Setting the Date and Time 35 Set th
Page 39 and 40: Attaching the Lens 37 All camera ex
Page 41 and 42: Adjusting the Viewfinder Diopter 39
Page 43 and 44: 3 Basic Operations This chapter exp
Page 45 and 46: 43 Letting the Camera Choose the Op
Page 47 and 48: 45 6 Review captured images on the
Page 49 and 50: Selecting the Appropriate Capturing
Page 51 and 52: 49 3 Press the 4 button. The mode p
Page 53 and 54: Using the Built-in Flash 51 Use the
Page 55 and 56:
53 3 Press the shutter release butt
Page 57 and 58:
Other Shooting Modes 55 Continuous
Page 59 and 60:
57 Set [No. cnt shtng rcd im] in [R
Page 61 and 62:
59 4 Use the four-way controller (4
Page 63 and 64:
Remote Control Shooting (Remote Con
Page 65 and 66:
63 8 Point the remote control unit
Page 67 and 68:
Playing Back Still Pictures 65 Play
Page 69 and 70:
67 3 Press the 4 button. Image rota
Page 71 and 72:
69 1 Press the Q button. The most r
Page 73 and 74:
71 3 Press the four-way controller
Page 75 and 76:
Processing Images with Filters 73 Y
Page 77 and 78:
Deleting Images 75 Deleting a Singl
Page 79 and 80:
Deleting Selected Images (from Nine
Page 81 and 82:
Protecting Images from Deletion (Pr
Page 83 and 84:
Setting the Printing Service (DPOF)
Page 85 and 86:
83 2 Press the four-way controller
Page 87 and 88:
Setting [Transfer Mode] 85 1 Press
Page 89 and 90:
87 3 Turn the printer on. 4 After p
Page 91 and 92:
89 10 Press the 4 button. 11 Repeat
Page 93 and 94:
Printing Images Using the DPOF Sett
Page 95 and 96:
4 Menu Reference Explains the funct
Page 97 and 98:
4 5 6 7 8 9 10 11 12 13 14 15 Focus
Page 99 and 100:
5 6 7 8 9 10 11 M button Press to s
Page 101 and 102:
Select a menu item and set 99 Proce
Page 103 and 104:
[H Set-up] Menu Setting Items 101 P
Page 105 and 106:
FI with S lens used Using aperture
Page 107 and 108:
Playback Mode 105 Press the { butto
Page 109 and 110:
Item Function Page e (Program) Auto
Page 111 and 112:
5 Function Reference Introduces fun
Page 113 and 114:
Setting the Recorded Pixels 111 You
Page 115 and 116:
Setting the Saturation/Sharpness/Co
Page 117 and 118:
115 Color Temperature The color of
Page 119 and 120:
Setting the Sensitivity 117 You can
Page 121 and 122:
Setting the Color Space 119 You can
Page 123 and 124:
121 2 Look through the viewfinder a
Page 125 and 126:
Setting the Focusing Area 123 You c
Page 127 and 128:
Fixing the Focus (Focus Lock) 125 I
Page 129 and 130:
Adjusting the Focus Manually (Manua
Page 131 and 132:
Setting the Exposure 129 Effect of
Page 133 and 134:
Selecting the Metering Method 131 C
Page 135 and 136:
Changing the Exposure Mode 133 This
Page 137 and 138:
Using the b (Shutter Priority) Mode
Page 139 and 140:
Using the c (Aperture Priority) Mod
Page 141 and 142:
Using a (Manual) Mode 139 You can s
Page 143 and 144:
141 About the L Button The aperture
Page 145 and 146:
Changing the Exposure Setting Steps
Page 147 and 148:
145 4 Press the 4 button. The camer
Page 149 and 150:
Checking the Composition, Exposure
Page 151 and 152:
Using the Built-in Flash 149 Compen
Page 153 and 154:
Using Slow-Speed-Sync 151 You can u
Page 155 and 156:
DA, D FA , FA J, FA and F Lens Comp
Page 157 and 158:
Using an External Flash (Optional)
Page 159 and 160:
Using High-Speed Flash Sync Mode 15
Page 161 and 162:
Red-Eye Reduction 159 As with the b
Page 163 and 164:
Contrast-Control-Sync Flash 161 Com
Page 165 and 166:
163 5 Press the OK button. The sele
Page 167 and 168:
Turning the Beep On and Off 165 You
Page 169 and 170:
167 7 Use the four-way controller (
Page 171 and 172:
Setting the Display Language 169 Yo
Page 173 and 174:
Setting Auto Power Off 171 You can
Page 175 and 176:
Displaying Histogram and Bright Por
Page 177 and 178:
Resetting the Custom Function Menu
Page 179 and 180:
6 Appendix Default Settings .......
Page 181 and 182:
[H Set-up] Menu Item Default Settin
Page 183 and 184:
Fn Menu Drive Mode Item Default Set
Page 185 and 186:
Lens names and mount names FA prime
Page 187 and 188:
Cleaning the CCD 185 Shadows may ap
Page 189 and 190:
Optional Accessories 187 A number o
Page 191 and 192:
Camera Case 189 Camera Case O-CC34
Page 193 and 194:
Error Message Image folder could no
Page 195 and 196:
Problem Cause Remedy AE lock functi
Page 197 and 198:
Exposure Mode Shutter Lens Mount Le
Page 199 and 200:
Glossary 197 AdobeRGB Color space r
Page 201 and 202:
Histogram A graph that shows the da
Page 203 and 204:
Memo 201
Page 205 and 206:
Color Temperature ...............11
Page 207 and 208:
Q Quality Level ..................3
Page 209 and 210:
equired, please keep the receipt or
Page 211 and 212:
Declaration of Conformity According
Page 213 and 214:
Memo
Page 215:
PENTAX Corporation PENTAX Europe Gm
show all

Press the - Pentax

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?