deva.metal Handbuch EN fÃ¼r GGB - Supresores

More documents

Recommendations

Info

Fig. 6.2.3 – Sliding piece Fig. 6.2.4 – Sliding bar Design Fig. 6.2.5 – DEVA ® Turret bearing Fig. 6.2.6 – Piston guide rod with balance bearings 16
deva.metal ® maintenance-free Fig. 6.2.7 – Angle compensation piece Fig. 6.2.8 – Guide bearing Design Fig. 6.2.9 – Flanged bearing 6.3 Design considerations of running surfaces Shafts and counter faces which run against deva.metal ® are normally produced from steel. It is recommended to use stainless steel or hard-chrome plated steel as counter materials for damp and corrosive environments – particularly if neither oil nor grease are available as basic protection. The determination of the counter material surface qualities and hardness has already been discussed in Chapter 4. Shafts and counter surfaces operating against the deva.metal ® bearings or thrust washers must extend beyond the bearing surface in order to avoid cutting into it. The mating surface must also be free from grooves or flats. The end of the shaft should be given a lead-in chamfer and all sharp edges or projections which may damage the deva.metal ® bearing must be removed. Fig 6.3.1 – Design considerations of running surfaces 17
Page 1 and 2: deva.metal ® Maintenance-free, sel
Page 3 and 4: deva.metal ® maintenance-free deva
Page 5 and 6: deva.metal ® maintenance-free 1 Ma
Page 7 and 8: deva.metal ® maintenance-free 3 Ma
Page 9 and 10: deva.metal ® maintenance-free stab
Page 11 and 12: deva.metal ® maintenance-free 3.4
Page 13 and 14: deva.metal ® maintenance-free 5 Fi
Page 15: deva.metal ® maintenance-free 6 De
Page 19 and 20: deva.metal ® maintenance-free The
Page 21 and 22: deva.metal ® maintenance-free 9.2
Page 23 and 24: deva.metal ® maintenance-free The

deva.metal Handbuch EN fÃ¼r GGB - Supresores

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?