FDB2 FIRE AND GAS DAMPER - Halton

FDB2 Installation, operation and
maintenance instructions
Version: 10
Date: 19.12.2012
1.4. ASSEMBLY IN MODULES
Modular dampers are usually shipped in separate modules with all necessary connection parts attached.
When assembling modules, please check that you have all the necessary parts:
- With dampers there are flat steel bars attached to the shipment
- Flat steel bars are equipped with appropriate size bolts for all threaded holes.
- 4-module dampers are also shipped with two cross-shaped connection pieces.
- A suitable amount of sealant material is supplied with each modular damper shipment.
If you cannot find flat steel bars or bolts for the threaded holes, please check the damper shipment for
attachments or other possibilities of loose items. If you are certain the flat steel bars, bolts or sealant
tubes are not with the damper shipment, please contact Halton Marine.
1.4.1. Sealant instructions
Instructions for applying Pyrocryl (or similar) sealant:
1. Check that the the each connection piece matches with the
damper modules before applying the sealant.
2. Apply a constant stream of sealant to each flat steel bar and the
cross pieces.
3. Install the flat steel bars and cross pieces as instructed.
Main sales office & factory
Tel. +358 (0)2079 2200
Fax. +358 (0)2079 22060
http://www.haltonmarine.com
Page 6 of 21