1974 TNT - Vintage Snow

Bulb
h",,,r1i,,nC1n is burnt, stop
cab latches (2) and ti It cab. connector
from Remove rubber
boot and unfasten bulb retainer ci Detach
bulb and replace. If taill bulb is
burnt, expose bulb by removing red plastic
lens. To remove, unscrew the two (2)
head screws.
Broken Throttle Cable
Remove cable and replace. Check
lever If necessary replace housing.
Warning: Before
hand!ebar
throttle lever must return swiftly to
its
Carl:unetor throttle
lel/sr must also return to an Idle position
U.lI.itteri!y Do not start unless
oot!'! are verified.
Broken Rewind Rope
Abuse of the starter may cause
the rope to fray and break. Should this
situation arise, remove starter unit
10 mm wrench supplied in tool kit.
Transfer rope grip to your emergency rope.
Make a knot at the end
starter rope and wind rope around starter
pullev. Pull
as per usual manual
start. See your dealer for immediate
repair or
of starter unit.
23