Clavister cOS Core Administration Guide

Chapter 4: Routing
Contents of the Policy-based Routing Policy:
Source
Interface
Source
Range
Destination
Interface
Destination
Range
Selected/
Service
Forward
VR table
lan1 10.10.10.0/24 wan1 all-nets all_services r2 r2
wan2 all-nets lan1 20.20.20.0/24 all_services r2 r2
Return
VR table
To configure this example scenario:
InControl
Follow the same steps used for the Web Interface below.
Web Interface
1. Add the routes in the list to the main routing table, as shown above.
2. Create a routing table called r2 and make sure the ordering is set to Default.
3. Add the routes found in the list above for the routing table r2.
4. Add the PBR routing rules according to the list with the following:
• Go to: Network > Routing > Policy-based Routing Rules > Add > Routing Rule
• Enter the information from the list
• Repeat to add the next rule
Note
Routing rules in the above example are added for both inbound and outbound
connections.
255